Specifications

1.suction oil filter element
2.installation into suction line
3.Filtration ratings of 74 or 125 microns
4.ISO Test

Stainless steel suction oil filter element

Inside tank suction filter element are designed for installation into suction

lines of pumps. Extra caution should be taken to ensure that the suction

elements are always mounted below the minimum oil level of the reservoir.

 

Features:

Standard models have nominal filtration ratings of 74 or 125 microns.The

suction strainer elements can also be supplied with a bypass valve to reduce

high pressure drops caused by contaminated elements or high viscosity fluids

during cold starting. The bypass valve opens at 3 psi. for best results, suction

strainer elements should be sized for clean element pressure drops of no higher

than 0.5 to 0.7 psi. HYDAC suction Strainer Elements are manufactured using

stainless steel wire screen media.

 

 

Attention:

Suction strainer elements are only intended to protect hydraulic pumps against

catastrophic failure caused by coarse contaminants. Suction strainer elements

should be inspected and cleaned regularly. Suction strainer elements should not

be used as the only filtration elements in a hydraulic system. Pressure filters and

return line filters, with reasonable dirt holding capacity, must be installed to provide

protection against component damage caused by fine contaminants.

 

Hydraulic Data
Pressure Drop vs. Flow: Pressure drop will be < 2 psi when strainers are used

within the recomended flow range, and with a standard hydraulic fluid with a

viscosity of 141 SSU and specific gravity of 0.86.