- When work,wear the personal guard to avoid the risk from Splashing of liquids.

- Mechanical vibration may leads to glass breakage.

- Being trapped of parts of the body, hair or pieces of clothing in the moving parts.

• During manual manipulation:

- Keep medium vessels vertical as much as possible.

- Mix the medium in the minimum pressure required.

- Use attachment supplied when mixing a mass of different medium.

• Set up the instrument in a spacious area on an stable, clean, non-slip, dry and fireproof surface. Do not operate the instrument in explosive atmospheres, withhazardous substances or under water.

• Put the speed control knob to the lowest position.

Gradually increase the speed (MX-S), reduce the speed if :

- The medium splashes out of the vessel because of too high speed.

- The instrument is not running smoothly or moves on the stage.

• Safe operation is only guaranteed with the accessories described in the “Accessories” chapter.

• Accessories must be securely attached to the instrument and cannot come off by y themselves.

• Check the instrument and accessories before hand for damage each time you use them. Do not use damaged components.

• Place a vessel at the centre of the mixing head and spread out others uniformly.

• A sharp edged vessel can wear-out the mixing head.

• Always disconnect the plug before fitting accessories.

• The instrument may heat up when in use.

• The operating voltage required on the label and voltage supply network must match.

• Protect the instrument and accessories from bumps and impacts.

• The instrument may only be opened by qualified and trained technician only.

II. Proper use

The instrument is designed for mixing liquids in schools, laboratories or factories. This device is not suitable for use in residential areas or other areas that may cause danger to the user or instrument as mentioned in Chapter 1.

III. Inspection

i.  Receiving Inspection

Unpack the equipment carefully and check for any damages which may have arisen during transport. If it happens, please contact manufacturer for technical support.