1. Technical Parameters

1) Outer dimensions(L*W*H):1620mm*1620mm*1550mm

2)Total weight of machine : 850kg

3)Diesel engine power : 12KW (16HP)

4)Weight of coating to be melted: 400KG*2(15-17bags of coating material)

5)Stirring speed : 0~80r/min

6)Stirring mode : Four helical blades can rotate leftwards and rightwards to move coating up and down.

7)Heating temperature : 0~300°C

8)Engine start method:Electrical(12V), Manual

9)Capacity of hydraulic oil tank :60L

10)Used fuel : LPG

2. Brief Introduction

TW-Y Hydraulic Double-cylinder  Pre-heater is one of the key machines for the construction of thermoplastic marking at present. With hydraulic drive as well as positive and reverse rotation controlled by multi-way reversing valve, the melting speed gets faster. It is mostly used in the construction of marking at the sites where fast melting is required such as freeway, State Highway, Provincial Highway etc.

It can be customized according to clients’ requirements, such as the customization of materials (Steel plate, Stainless plate), overall dimension, capacity of kneader cylinder, and designated installation mode of diesel engine, and designated installation mode of diesel engine.

Components

3.Small Size Single  Cylinder preheater

4.  Hand-guided Line Marking Machine

1) Stable:

Through gravity adjustment, widened front wheel, the Marking Machine is more stable than traditional ones when marking 450mm zebra crossing.

2)Lighter:

Through repeatedly gravity test, rechoose new shaft, the marking machine is much lighter, reduced operator’s working intensity. So the marking works become easier and more effectively.

3)Easy to operate:

Marking hopper’s operating range minimized from 300mm to 200mm, more accurately , easier to control, therefore such problems as slow hopper withdrawal and uneven finishing mark edge are solved. A multi-point sliding block pressing structure is used to avoid material leakage witch often occurs to similar products due to the two tightly pressed sides and large deformation in the middle of product alike.

Technical parameters