TM-UV1000 UV drying machine  

video :/v_show/id_XNjYzMTUxMTcy.html

Technical  parameters

sample

Application
It is apply to the special effects such as wrinkle, frosted refraction gem crystal and convex oil on the bullion paperboard, metal, glass, plastic, and also the UV curing of the offset printing ink on the offset press production.

Features
1.With Teflon or stainless steel net, transmit speed steady and can be adjusted.
2. With two UV lighting tubes, can turn on the light according to the need.
3. Wink-dry make the surface of the stocks high hardness and rub resistance.
4. Tunneling-based make the whole machine light barrier good and without harm.
5. Equipped with powerful nether induced draughe system and big intake airway, can absorbs the stock on the mesh belthard.5. Equipped with powerful nether induced draughe system and big intake airway, can absorbs the stock on the mesh belthard.
It can be used with production line and other equipment easily.

control  system
It is used to control the whole light solid machine work system
please kindly note
1. Fan control by the best temperature automatic control (see right-hand chart), because there may be omissions control by people, also is not accurate enough.
2. This boot should first turn on the light, 2 to 3 minutes to open the fan (fan is not temperature control, this time for the UV machine had been set before shipment).
3. Should take the fan continues to run after shutdown, until the lamp and body cooling.
4. The second starting to wait until completely cooling tubes starting. 

ventilating system
It consists of fan, air duct, the wind mask. Here is that should be paid attention to the choice of fan and air volume control and ventilation.
1. The selection of the fan according to the UV lamp power and the actual situation of housing space. General distribution and convulsions two wind turbines, but I have only small UV machine equipped with a ventilation fan. Fan power is not enough that leads to exhaust air temperature inside the case,  lamp life shortened, melt, even also make curing product quality difficult to guarantee; Air volume of fan power if too large, will make the temperature inside the case is too low, the UV lamp can't work at full power, curing is not easy to dry 
2. Exhaust way refers to take the lead wind supply air or air supply on the wind, etc. But either way, not the wind blows directly to the UV lamp, because the consequences of doing so is to make the UV lamp for heat loss is too big and not full power work (changed from white to not dazzling light blue), make the ink doesn't dry.

Payment Terms
TT/LC/ Western Union

If you have any question, please contact us!