The stable robust, all welded steel frame from ultrasonically tested plates are of top quality. Ram
and table designed with special inclined member and box type structure for maximum strength.
The top beam is guided by three point roller with replaceable hardened liners for least wear.This eliminates lubrication of guides. Roller guide made of hardened & ground bearing steel to provide better quality of cutting for a long time.
Rake angle can be varied to permit shearing of higher thickness than nominal capacity and facilitating distortion free shearing of thin sheets.
The fastest and easiest way of blade clearance setting without need of feeler gauge, which helps
Burr-free edges.
Positive holding by hydraulic holddowns before shearing avoids slippage of sheets and independent operation of holddowns for clamping of sheet helps checking of mark without taking shear stroke.
Front gauging by disappearing stoppers mounted on left squaring arm. Robust, heavy & accurateback gauging to set cutting width.
Hydraulic cylinder are designed with both low and high pressure sealing, Hard chrome plated rod also with special type guide for long life without leakage.
Hydraulic components of international quality assembled in our own factory with specially designed compact manifold
STANDARD ACCESSORIES |
|
- Main Drive motor
- Electric Control Panel
- Operational Console
- Pre selector switch to adjust rake angle
- Lever operated blade clearance with calibration
- Fine stroke adjustment rod with limit switch
- Front sheet support
- Squaring arm on right end with steel rule
- Hardened transfer bar mounted on table
- Hold down cylinders
- Shadow light Indicator
- Four edge HCHCR / HCSR blade interchangeable & suitable to shear mild and St. Steel
- Manual back gauge
|
OPTIONAL ACCESSORIES |
|
- Second squaring arm on left side
- Motorised back gauge with DRO
- NC back gauge with ball screw
- Front support with rolleraccording to required length
- Rear sheet support
- Ball transfer table
- Degree protector for angular cutting
- Stroke counter
- Design with throat depth
- First fill of hydraulic oil
|
Main Products: Lathe Machines ,Drilling Machines ,Milling Machines ,Presses ,Sheet Shearing - Bending - Rolling Machines
Business Type: Trading Company,Distributor/Wholesaler
Maharashtra India
Facebook
X
Pinterest
Linkedln