INSTRUCTIONS FOR USE

·This product consists of Light Emitting Diodes (LEDs) connected in a series and parallel arrangement and is used to extend connectable series of light sets.

·This product is fitted with a connector suitable for connecting additional sets of LEDs.

·To connect to another connectable light set:

a)Disconnect the light set from the power supply

b)Unscrew the connector cover at the end of the light set being extended.

c)Remove 3 pin plug, (if fitted) from the new light set by unscrewing the connector.

d)Connect the new light set to the end of the light set being extended.

e)Make sure all gaskets are in place and connectors are secure with all the covers screwed on tight.

f)Always make sure the connector cover is in place at the end of the last light set.

·A maximum of 5000 LEDs can be safely connected together to operate from a single plug.

·Make sure that the cable is completely unravelled and that there are no snags in the cable.

·To operate, plug into mains supply indoors not outdoors or in damp conditions.

LEDs

Non-replaceable LEDs - 3V 0.06W

PLUG

All connectable light sets are protected by a 3 amp fuse. Replace only with a 3 amp fuse.

EXTENSION LEADS

 - 5M Extension Lead

 - 15 Extension Lead

POWER SUPPLY

Rated Voltage / Wattage: 230V 50Hz8.2W per100 LEDs

Max Rated Voltage/Wattage for 5000 LEDs: 230V 50Hz 300W

.

·Do not connect this light set electrically to any other light set apart from LI096522, LI096524, LI101756 and LI101757 (All available in Blue, Blue and White, White and Warm White).

·Do not connect more than maximum of 5000 LEDs