Our picture:

Our Canton Fair:

Advantage:

What is the difference between manufactured stone veneer and natural stone?

Manufactured stone veneer is cast from molds of real stone which makes it lighter than natural stone. Natural stone may require wall ties and footings, which, in turn, can increase installation cost and difficulty. Manuka’s architectural stone veneer is lighter weight, designed to adhere easily to a variety of structurally surfaces.

What are the benefits of using manufactured stone?

Installed, manufactured stone is approximately 1/3 to 1/2 the cost of natural stone. Its light weight properties eliminate the need for wall ties or footings. Manufactured stone has a 2% (approximately) waste factor versus 10% or more for natural stone.

Why us?

How does Manuka Stone withstand freeze / thaw cycles?

Manuka Stone products are tested for freeze/thaw durability. As with any installation, making sure to incorporate good building practices that include proper flashing and water diversion techniques will help ensure a successful installation.

Will Manuka Stone fade?

The base color is blended throughout and permanent mineral oxide pigments are applied and absorbed when the veneer is cast. Color becomes an integral part of the veneer and, similar to natural stone, there are minimal noticeable color changes after years of weathering.

Where can I install Manuka Stone?

Manuka Stone can be applied to any structurally sound surface with the proper preparation. It fits nearly any building plan — large or small, interior or exterior, new residential or commercial projects - or on any remodel.

Can I install Manuka stone myself?

In general, installation of Manuka Stone can be installed by almost anyone. However, installation does require a fundamental understanding of stone masonry.

How important is a good stone installation?

As with any building material, the beauty of that product is greatly enhanced by how well it is installed. With Manuka Stone, careful consideration regarding the type of profile and color selected, the actual installed stone “pattern”, and the type of grout technique used, are all very important factors to regard. It is always best to create a mock up board with the desired aesthetic appeal prior to installation on your project.

Can I install Manuka Stone near water?

It is not recommended for use below the water line in a pool, a fountain or below grade. Due to the large amount of water or moisture in the area, our product will be at risk for deterioration or discoloration. We would recommend using a natural stone in these types of applications.

Can we install Manuka Stone around a fireplace?

Manuka Stone can be installed around a fireplace. The veneer has to be a minimum of 18" from any open flame.

What measures should be taken for hot /cold weather installations?

For cold weather installations ambient temperature should be 40ºF or higher at the time Manuka Stone veneer is applied. If the temperature is below 40ºF, mortar should be heated between 40ºF – 120ºF (not to exceed 140ºF). Any mortar that freezes should be discarded. Wall surfaces may need to be covered and heated after installation of veneer to avoid freezing the mortar. Mortar should be kept under 120ºF and be used within 2 hours of initial mixing.

Thank you for your visiting. Any help, please do not hesitate to contact us.