Product Details

China good quality silicone rubber kneader manufacturers

Product Description

1. introduction of silicone rubber kneader :

1). Functions: mixing, kneading, crushing and dispersing for high-viscosity liquid materials, with no dead point.

2). Components: kneading part, base part, transmission system, vacuum system, hydraulic system, electric control system, etc. Two sigma or Z-type blades.

3). Equipped with inverter for frequency control.

4). Vacuum and high pressure are available.

5). Discharge mode: Hydraulic tilting, Bottom pumping,or Screwing.

6). With jacket outside of the cylinder, for heating or cooling.

7). Heating mode: Hot oil, Electric or Steam

8). Widely used in high viscosity sealant, silicone rubber, CMC, adhesive, also used in batteries, ink, pigments, dyes, pharmaceuticals, resins, plastics, rubber, cosmetics ect.

2.The technical parameters of silicone rubber kneader :

Model	Volume	Motor power	Discharge mode	Heating & Cooling	Vacuum degree (Mpa)
NHZ-5	5	1.1-2.2	Hydraulic tilting	Oil/ Steam/ Electric heating Water cooling	-0.098
NHZ-10	10	1.5-3
NHZ-20	20	3-5.5
NHZ-50	50	4-7.5
NHZ-100	100	5.5-7.5
NHZ-200	200	7.5-15	Hydraulic tilting/ Screw discharge/ Bottom discharge
NHZ-300	300	11-18.5
NHZ- 500	500	18.5-30
NHZ-1000	1000	22-55
NHZ-2000	2000	45-75
NHZ-3000	3000	55-110
Data in this table for reference, the actual data according to specific process requirements, material viscosity and other design.