Product Details

Overview of Machine

Jerry can plastic extrusion blow moulding machine

Model:TVHS-20L

Accumulator die-head
70mm screw/15kw motor
Pure hydraulic clamping system
100 points MOOG Parison Controller
YUKEN clamping system
SCHNEIDER electric parts
Working Condition:

Power Supply: 380V/50HZ, 3-Phase

(According to Clients' country)

Water Source: 15HP water chiller

Air Source: 0.6 Mpa,0.6 m³/min

(1 m³/min air compressor)

Images of samples

This series is applicable for PP,PE,raw material, and volume between 10L-20L, it is widely used in plastic barrel, tool boxes, hollow desk board, chairs, auto parts and other large and medium-sized plastic hollow products.

Adopts two pull-rod type closing-mold device by rack and pinion system. The large setting platen is suitable for various sizes of moulds.

Our machine adopts famous brand in most component parts, almost from GERMANY, JAPAN, FRANCE, TAIWAN

Parameters

Category	Item	Unit	Parameter
Basic Specification	Raw Material	--	PE etc.
	Container Capacity Max	L	20
	Machine Dimension	m	3.5×3.4×3.3
	Total Weight	kg	7200
Extrusion system	Diameter of screw	mm	70
	Screw L/D ratio	L/D	28:1
	Screw rotating speed	r/min	10-85
	Plasticizing capacity	kg/h	80
	Drive motor	kW	15
	Heating power	kW	18
Die head	Die head material	--	38CRMOALA
	Accumulator volume	L	3.7
	Accumulator capacity	kg	2.8
	Heating power	kW	8
Clamping system	Platen size (W x H)	mm	700×850
	Clamping range	mm	300-800
	Clamping force	kN	200
Power consumption	Servo pump power	kW	11
	Total Power	kW	52
	Average power Consumption	kW/h	22
	Air consumption	m3/min	0.6
	Water consumption	m3/h	1.2

Blowing technology:

Basic Configuration

1.Plasticizing System:

Screw& Barrel: High quality nitriding steel 38CrMoAlA for long working life.large L/D ratio design,ensure material equally processed, extruder stably.

Die –head:First-in First-out(FIFO),center-feeder/customized design.

2. Drive mode:

inverter + hard gear surface decelerator,lower consumption,low noise,balanced and stable screw rotation.

3.Temperature controller:

PID&PWM heating model,accurate control

4.Clamping system:

Fixed clamping system, three platen,SMC cylinder ,wider space for the mould, install and dismantle the mould easily, linear roll guide rail.

5.PLC and HMI:

Adopt PLC to control the action program of the whole machine; adopt HMI for communication, parameter setting, modification and picture display;

6.Electric Parts:

Schneider Brand,high reliability,long working life.

Our service