Model Trimmer

Model: MCD-ST001

Structure:
Frontispiece:1.Angle plate:Use the kob7 to adjust the angle
2.Replace the sand tablet 16.Loosen the plum-blossom knob on the left side of the rear cover .18. Press the sand tablet 1with the internal angle wrench. Remove and replace. Rear and lower part: Power sockets 22 is on the bottom right of the outer cover. The power switch 21 is on the upper-right of the outer cover. The water pipe 23 is on the cove of the rack bottom.
Specifications:470m/m×380m/m×390m/m
N/W:20kg
Sand tablet diameter:254m/m,sand tablet aperture :25.4m/m
Mechanical capability: 1.Voltage 220VAC/50~50~60Hz/7A, Output 1/3 horsepowe
2.Voltage 220VAC/50~50~60Hz/3A Output:1/3 horsepower
Use : 1.Connect the water pipe to the nozzle, connect the other end to the tap, then open the valve.
2.Connect the sewage drain to the outlet, and then stretch the drawtube.
3.Connect the power, and then open the power switch (oturn off / turn on).The machine adopts no-load brake (stop the free running sand tablet quickly).It is normal to hear clicking sound before the sand tablet stops.
4.While the sand tablet makes big noise or unusual sound, removeit, use the six-angle wrench to fix the screw on the bushing in the rear cove18.
5.Replaced with new sand tablet, put hard reglet on the platform 8(closest of the sand tablet).Use hand to rotate the sand tablet and estimate. If the jumpiness of the platform is even faster than 2m/m, please do not use this sand tablet, suggested to change a new sand tablet, which the jumpines of the platfor is smaller than 2m/m.