MODEL

PS-65-3.3

OUTPUT

DC VOLTAGE

3.3V

RATED CURRENT

12A

CURRENT RANGE

0 ~ 15.2A

RATED POWER

39.6W

OUTPUT POWER (max.)

Rated output power for convection; 72W (+3.3V : 50W;+5V:69W) with 18 CFM min. Forced air

RIPPLE & NOISE (max.)   Note.2

80mVp-p

VOLTAGE ADJ. RANGE

3.14 ~ 3.63V

VOLTAGE TOLERANCE Note.3

±3.0%

LINE REGULATION    

±1.0%

LOAD REGULATION    

±3.0%

SETUP, RISE TIME

800ms, 20ms at full load

HOLD UP TIME (Typ.)

60ms at full load

INPUT

VOLTAGE RANGE

90 ~ 264VAC        127 ~370VDC

FREQUENCY RANGE

47 ~ 440Hz

EFFICIENCY (Typ.)

69%

AC CURRENT (Typ.)

1.2A/115VAC         0.72A/230VAC

INRUSH CURRENT (Typ.)

COLD START 20A/115VAC         40A/230VAC

LEAKAGE CURRENT

<0.75mA / 240VAC

PROTECTION

OVER LOAD

73 ~ 105W(3.3V : 51 ~ 75W)(5V : 70 ~ 105W) rated output power

Protection type : Hiccup mode, recovers automatically after fault condition is removed.

OVER VOLTAGE

3.8 ~ 4.46V

Protection type : Hiccup mode, recovers automatically after fault condition is removed.

ENVIRONMENT

WORKING TEMP.

-10~+60°C (Refer to derating curve)

WORKING HUMIDITY

20~90% RH non-condensing

STORAGE TEMP., HUMIDITY

-20~+85°C, 10~95%RH

TEMP. COEFFICIENT

±0.04%/°C (0~50°C)

VIBRATION

10 ~ 500Hz, 2G 10min./1cycle, Period for 60min.each along X, Y, Z axes

SAFETY&EMC

(Note 4)

SAFETY STANDARDS

UL60950-1, TUV EN60950-1 approved

WITHSTAND VOLTAGE

I/P-O/P:3KVAC   I/P-FG:2KVAC    O/P-FG:0.5KVAC

ISOLATION RESISTANCE

I/P-O/P, I/P-FG, O/P-FG:100MOhms/500VDC/25°C/70%RH

EMC EMISSION

Compliance to EN55022 (CISPR22) Class B, EN61000-3-2,-3

EMC IMMUNITY

Compliance to EN61000-4-2,3,4,5,6,8,11, EN55024, light industry level, criteria A

OTHERS

MTBF

300.7K hrs min.     MIL-HDBK-217F (25°C)

DIMENSION

127*76*42mm (L*W*H)

PACKING

0.21Kg; 54pcs/14.2Kg/1.35CUFT

NOTE

1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25°C of ambient temperature.

2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.

3. Tolerance: includes set up tolerance, line regulation and load regulation.

4. The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets EMC directives.

5. Mounting holes M1 and M2 should be grounded for EMI purposes.

6. Heat Sink HS1,HS2 can not be shorted.