Sinft 0.1 micron home pure water filter  

Description of Sinft 0.1 micron home pure water filter : 

0.1 micron ceramic filter cartridge reduces protozoan cysts and fine sediment in residential drinking water. It has a nominal (85%) filtration rating of 1 micron, and 99.95% efficiency for the removal of protozoan cysts. This cartridge is made of sintered ceramic media with thermoset polymeric end caps for strength and rigidity. The nitrile butadiene rubber (Buna-N) gasket seals the cartridge against the housing (sold separately). This filter can be cleaned several times with a sponge or nylon brush. The cartridge has an initial pressure drop of 19 pounds per square inch (psi) at a recommended flow rate of 1 gpm, and it operates over a temperature range of 40 to 125 degrees F (4.4 to 51.7 degrees C). This ceramic filter cartridge is for use in residential drinking water purification.

High temperature filter system  of Sinft 0.1 micron home pure water filter  :

 High temperature filters are chemically inert and highly corrosion-resistant, as would be expected from ceramic materials. 

• Particulate matter (PM) is removed to ultralow levels (<2 mg/Nm3, 0.001 grains/dscf). Very effective on submicron PM.

• SO2, HCl, HF, and other acid gases treated at over 90% removal using integrated dry sorbent injection.

• NOx destruction over 90%. In addition to treating PM and acid gases, the catalyst filters have nanobits of NOx catalyst embedded throughout the filter walls. These filters provide very effective NOx destruction using integrated aqua ammonia injection. Replaces conventional SCR.

• NOx destruction takes place at lower temperatures than standard SCR big-block reactors that require 650°F, with good destruction as low as 350°F and over 90% at 400°F for many applications. Equally effective at higher temperatures.

• Dioxins (up to 99%) and mercury (varies with form) can be removed within certain temperature ranges.

Features of  Sinft 0.1 micron home pure water filter:

Reduces fine sediment and protozoan cysts in residential drinking water

Nominal filtration rating of 1 micron and 99.95% reduction of cysts

Sintered ceramic filter media with thermoset polymeric end caps can be cleaned several times

Initial pressure drop of 19 psi at a flow rate of 1 gpm

Temperature range of 40 to 125 degrees F (4.4 to 51.7 degrees C)