LittleBee 30A ESC with BLHeli,OneShot125 and Damped Light

With all the great features of the  20A Little Bees, this 30A variant gives you the headroom needed for powerful 6" 4S setups. These ESCs now supprt up to 6S LiPos and are capable of handling 30A current with up to 10s 35A bursts.

Don't forget - these ESCs have no BEC so you will still need a 5V power source for your flight controller, receiver, etc. Have a look at the related items below for suitable a suitable PDB and BEC. You may also need bullet connectors unless you intend to solder your motors direct to the ESCs.

- Silabs MCU and High Speed ICs
- 35 x 17mm size (Super Mini and Lightweight)
- Pre-Flashed with BLHeli Firmware V1.4X
- Oneshot125 available - Faster communication between flight controller
- Damped Light Mode available
- 2-6S support with 30A continuous load and 35A peak (10 seconds)
- Bootloader Enabled - you can flash new firmware and configure settings via USB using the servo cable (requires USB linker)

  LittleBee 30A ESC with BLHeli,OneShot125 and Damped Light

Specifications:

- Input Voltage: 2-6S Li-Po Battery
- BEC Output: OPTO (you need to power up your flight controller using an UBEC)
- Continuous Current: 30A (Burst Current: 35A for 10s)

- Size: 35 x 17mm
- Weight: ~11g (including wires)
- Motor wire length: ~70mm (may vary from time to time)
- Battery wire length: ~90mm (may vary from time to time)
- Firmware: BLHeli
- Supports Damped Light Mode
- Main IC: SILABS C8051F394
- MOS: ALL N FET, AOS COMPANY
- MOS is driven by the non - transistor (drive tube)