Specifications

0.6W DC24V LED backlight for light box SL-BM008-E006
1. 55lm
2. Easy to install
3. Warranty:2 years
4. Save money.

2.4W DC24V LED backlight for light box    SL-BM008-B024

 

1. Specification

 

(1)Standard Accessories

flat head screw:8PCS

Screw:4PCS

E-connector:4PCS

Insulation pad:4PCS

 

 

(2)Optional Accessories

IR CONTROLLER 

 

 

 

 

 

 

 

 

 

 

 

2.Dimension(mm)

 

 

 

 

3.Connection 1:

 

 

 

Connection2:

 

 

Installation:

 

1.Non-mechanical extrusion on the LED light board and its components,

 

2. Protect the PCB light board during installation.

 

3.,Meet the requirements and safety standards of electronic components before installing LED light board (in the case of live work), don’t live operation, prevent short circuits.

 

4. It can be directly input DC/AC24V power. If it is installed with dimming remote, entering a remote control input terminal of the power supply output DC24V, again from the remote control output terminal connected to the circuit board, as shown above single dimming connection, and then its dimmable function works.

 

5. When install a large area, the PCB board should be put in the same direction, so that the PCB board positive +to positive +, negative -to negative -. After fixing with screw lock E-type gaskets connection, maximum connection 10 pcs with one power.

 

6. Each piece of the input voltage is DC24V, the input voltage can not be used directly with AC220V. 30x30cm per sheet lamp, the board power is 8W, Noted that the input voltage DC24V + corresponding to the lamp panel +, the input voltage of the the DC24V-corresponding lamp panel - , not allowed reversed connection.

 

7. Maximum power supply. 150W 24V switching power can supply up to 18pcs 30X30CM light board (8W).

 

 

                 Connection with no dimmer

 

 

 

4.LED Features

 

Model	Size/mm	LED Q’ty	Luminous flux	Input voltage	Total Power
SL-BL007-A080	300*300*10	96	600LM	DC/AC24V	8W
SL-BL007-B020	75*300*10	24	150LM	DC/AC24V	2W
SL-BL007-C020	75*300*10	24	150LM	DC/AC24V	2W
SL-BL007-D020	300*75*10	24	150LM	DC/AC24V	2W
SL-BL007-E006	75*75*10	6	40LM	DC/AC24V	0.6W
SL-BL007-F006	75*75*10	6	40LM	DC/AC24V	0.6W

 

 

 

Specification of each LED chip:

NO.	Item	Units	Parameter range
1	limited voltage	V	DC3-3.4V
2	LED current LED	mA	20mA
3	Emitting Angle	°	120°
4	Wavelengthλd(nm)Or Tc(k)	K	5500-8000K
5	luminous flux	LM	7-8LM
6	working environment	°C	-20~~+50
7	storage condition	°C	-30~~+70

 

Application 

 

 

 

 

5. Use manual

Please read the specification first to make sure the using condition is fit.

Please shut off the switch before connecting the product.

OUTPUT:DC24V/AC24V

Indoor use only.

 

6. Package