2015 Sound Acoustic Diffusers
Negotiable /Square Meter
Min.Order:100 Square Meters
Guangzhou Liyin Building Material Co., Ltd.
Diffuser Acoustic Of Theater Heat Resistant Acoustic Insulation Material
Sound Diffusers Acoustic Panel Leather Sound Insulation Acoustic Panel
MDF 3d Acoustic Panel Wall Wooden Diffusor Home Theatre Architectural Acoustic Panel
3d Wooden Acoustic Diffuser Wall Panel Acoustic Treatment Studio
3d Acoustic Wall Panel Wooden Sound Diffuser Sound Proof Acoustic Board Of Cinema
Decorative Acoustic Diffuser Panel Acoustic Treatment Home Studio
2015 Sound Pyramids Acoustic Diffusers
Leeyin Acoustic Diffuser constists of frame, fiberglass and fabric.
They can be used in conjunction with several other acoustic products such as grooved acoustic wall and ceiling panels. By using the various products in differing combination, better acoustic results can be easily reached.
Installation:
1.PREPARING
1)constructing location: keep dry, the temperature should be higher than 10'C, the widest humidity range should confined to 40%-60% after construction 24 hours before constructing, the location should reach the standards as above.
2)acoustic panels: for the acoustic panels accommodated to the circumstance of constructing, please place the panels in the constructing location for 48 hours, check up the type, specification and amount of the panels before constructing.
3)keels: fix the keels on the wall flatly according to the plan, the keels should be flat, slick, no rust, no metamorphosis; the wall must be construct according to the standards, the keels suitable install with acoustic panels, leave smaller than 500mm space between each wooden keel(smaller than 600mm of light steel keel), install the keels vertically with acoustic panels.
2.FIXING
1)siz of wall: all panels should be installed in accordance with the manufacturers recommendations.
2)cutting: all necessary hardware and accessories for a complete job installation are to be furnished by the contractor.
3)install the acoustic panels: the installation of acoustic panels should be carried out in a sequence from the left to the right, from upside to downside, the panels are cut to fit on site, traditional woodworking tools are suitable for cutting the panels, if panels are cut using a fine tooth table saw the panels should be cut face up to avoid scratching and at a much slower speed to avoid any tearout or chipping.
4)fix on keel:
1)wooden keel fixing using nails, staples or screws into prefixed timber battens on the walls via the tongue and groove joint.
2)also can fixing by: Light Steel Keel(size: 18*26*3000mm, use clip(size: 45*38mm) to fix.(needs 2.1m of keel and 17 clips per m2)