AC/DC/IR Hipot Tester

Specifications

1.   Constant output voltage: Output voltage accuracy is controlled within ± 1%. The output voltage will not vary with the input power supply and the external load. 
2.  Test mode is programmable
3.  ACW to DCW to IR automatic switching function
4.  Voltage rise, voltage fall, test and dwell time programmable
5.  Optional supply voltage 110V/220V, the frequency range from 40.0Hz to 400.0Hz; The tester will first check whether the input power supply right connected to N,L,G automatically after power on and give the prompt information if any of misconnection
6.  Key lock, preventing operators from modifying testing parameters 
7.  After the DCW and IR test is finished, the tester will discharge automatically within 0.2s, which ensure the safety of the operator.
8. Open-circuit detection, which avoid the misjudgment when the test cable is out of the tester.
9. Zero Crossing Turn-on Operation, which prevent the damage to the DUT
10. Voltage rises as time, Controllable Ramp-up Time, seeking for the breakdown points
11. Can set the current upper-limit and lower-limit
12. Current off-set function
13. Max. 30 memory group setting. And each memory can be set 99 test steps
14. Remote 9-pin PLC interface terminal on the rear panel for “start” and “stop” control.
15. Standard PLC interface, optional ports: RS232C, RS485, GPIB, USB
16. Test results which maximum can be up to 9999 can be stored inside the tester or sent to the computer through RS232

 Technical Specification