Specifications

Contact information:

Opto Bass PB12

Opto Bass PB10

Features and Specifications

Opto Bass PB12

Power amps:

• Very efficient class A/B power section for a more musical sound.

• By passable classic style high quality Opto-coupler compressor built in.

• Power: 180 W rms; 356 W peak @ 8 ohm per channel.

• Dynamic Headroom 3.29 db @8 ohm 3.26 db @4 ohm

• Phase delay than <.5%.

• THD Distortion: <.08%.

• Frequency respond 20Hz-25KHz

• Damping > 1000 from 20Hz-400Hz at 4 ohm. Good for clear and tight Bass tone

• Slew rate > 60 v/μsec.

Using a custom designed high-energy ferrite transformer with an optimized HF switching power supply that generates an incredible amount of energy for extremely fast dynamics and no 60 cycle Hum. With our PFC technology the Opto Bass PB12 can operate for the input from 90Vac to 240Vac.

Preamps:              

Features FET technology on all stages for a more natural tube-like sound.

Speaker:

Neodymium magnet speaker 12”, 8ohm 250Wrms with special cone for gui 

Using a custom designed high-energy ferrite transformer with an optimized HF switching power supply that generates an incredible amount of energy for extremely fast dynamics and no 60 cycle Hum. With our PFC technology the Opto Bass PB12 can operate for the input from 90Vac to 240Vac.

Preamps:              

Features FET technology on all stages for a more natural tube-like sound.

Speaker:

Neodymium magnet speaker 10”, 8ohm 100WRMS with special cone for guitar

A. Drivers are being assembled on the production line

B. Electronics are being assembled on the production line. 

C. All products 100% go through ATS test.

D. Workers are plugging in parts to PCB.

E. SMT workshop.

F. Loudspeakers are being assembled on the production line.

For over 50 years musicians and home HIFI audiophiles have known that vacuum tubes are the best electrical device for sound quality. Unfortunately tube amplifiers are hot and heavy and not always reliable, tubes burn out. In recent years many amp manufacturers have replaced tubes with IC Op-amps and solid state transistors. The benefit was small size and efficiency but the sound quality suffered. They are not as musical as vacuum tubes.

Now we present a new Bass amplifier the Opto Bass PB12

The Opto Bass PB 12 has been designed and built by people who have their own experience with bass sound and quality very seriously. That is why this product was designed with Discrete FET (Field Effect Transistor). The sound of FET is far better than the IC’s op amps sound because the FET operates in a manner somewhat analogous to vacuum tubes.

More over the Opto Bass PB12 is combined with our custom design 12” speaker VINTAGE ND12B200.  This 200 Watts neodymium magnet speaker with special paper cone for Bass tone make a warm and fat Bass sound and reduced the weight of speaker. This Opto Bass PB12built with the most care in order to meet all professional standards

Our goal was not only to design an amp which sounds fantastic and is easy to operate, but also to build it in such a way that it will serve you loyally for many years to come. Since this amplifier is lightweight it is easy to carry to every place.