Product Details

ITC T-1D120R Series 120W to 500W APFC Mono Class D Amplifier with RS232

Appearance

ITC T-1D120R Series 120W to 500W APFC Mono Class D Amplifier with RS232

Rear Panel

ITC T-1D120R Series 120W to 500W APFC Mono Class D Amplifier with RS232

Connection

ITC T-1D120R Series 120W to 500W APFC Mono Class D Amplifier with RS232

Product Description

ITC T-1D120R Series 120W to 500W APFC Mono Class D Amplifier with RS232

The range of one channel power amplifier is Class-D series. From one hand, switch power technology with APFC (Active power factor correction), had enhanced the efficiency up to 85%. From another hand, this amplifier is also preferable for much more heat generation of less than 55 degrees even at severe working conditions, thus this benefits are not only good for extension of life span. The amplifiers are designed to be both tabletop and rack mount in 1.5U height. The output power of this series is 120W, 240W, 350W and 500W. On the real, there is one line 100V output to connect with speaker. A line input by phoenix connector for remote control and status monitor. There is also a RS232 interface for remote control volume, remote read product status, remote control standby. Extensive protection includes high temp, overload and short-circuit.

Feature

ITC T-1D120R Series 120W to 500W APFC Mono Class D Amplifier with RS232

* Built-in active filters bandpass signal to effectively filter out useless audio signal.

* A balance input, 1 channel power output of 120W/240W/350W/500W.

* Independent volume control.

* LED indicator includes signal, peak, protection, power supply signal.

* With amplifier monitor output, standby control and standby cascade port.

* With RS232 interface for remote control switch ON/OFF, and monitor working status, to fulfill four channel volume control and read fault output, and trigger amp standby.

* With DC24V input, with wide voltage range protection (21.6 ~ 26.5Vdc), to avoid damage

to equipment in case of long-term feed failure from backup battery or voltage is too high.

* AC110V or 230V and DC 24V operation.

* Output: 100V.

* Electrical isolation for device, signal input and output, it is 3C, UL, IEC60065 certification standards.

* Built-in short circuit, overload, overheating protection.

Specification

ITC T-1D120R Series 120W to 500W APFC Mono Class D Amplifier with RS232

Model	T-1D120 R	T-1D240 R	T-1D350 R	T-1D500 R
Rated Power Output	120W	240W	350W	500W
Speaker Output	100V
Input Sensitivity & Impedance	±385mV/20KΩ,balanced H5.08 European connector input
Overload Electromotive Force	>11dB, balanced H5.08 European connector input
Frequency Response	80Hz~18KHz(+1dB, -3 dB)
S/N Ratio	≥85dB
THD	≤0.5% at 1KHz, 1/3 rated power
Controls	Remote volume control, power control, standby control and status monitor (phoenix connector); Remote control volume, remote read product status, remote control standby(RS232 port).
Indicators	signal, peak, protection, power
Protection	high temp, speaker DC output ,overload and short-circuit
Cooling	Forced cooling(half speed control start up 50℃; full speed control start up 70℃ )
Power Consumption	150W	300W	420W	550W
Power Supply	~230V 50Hz(can be customized to be AC110V 60Hz) DC24V( 24V DC battery standby)
Dimensions	484×440×66mm
Weight	7.6Kg	7.8Kg	7.9 Kg	8Kg