Specifications

1.injecting pressure
2.atomizing quality
3.injecting angle
4.needle valve seals
5.high quality

 

PS400A-II Nozzle Tester

 

 

Main technical parameters

 

1.     diameter of pressure gauge    150mm

 

2.     pressure gauge range         0∼60MPa

 

3.     pressure gauge accuracy rating  0.4

 

4.     largest tested pressure        60MPa

 

5.     capacity of fuel tank         1.6L

 

6.     overall dimension (L×W×H )   250mm×150mm×480mm

 

7.     net weight                13Kg

 

 

 

 

Testing of injection pressure of injector assembly Turn the injector assembly tested onto the nozzle joint tightly with high pressure pipe then do the experiment and adjustment of pumping fuel. When pumping fuel, watch the reading on the pressure gauge at the same time,compare it with the specified pressure range of the injector assembly to see if it is normal.If the pressure is too high or too low, adjust the pressure spring of injector assembly.   5.Adjuestment injecting angle. Test the injecting angle ensure the injecting pressure is adjusted.Put a piece of white paper or a piece of iron-wire net painted with grease under the nozzle in the distance.

  

     1.Calibrating fuel must be good quality light diesel deposited over48 hours. 2.When filling fuel,filter it with silk-cloth.Do not fill tank with unfiltered diesel. 3.Cover the tester with anti-dust cover after testing.