Specifications

1.S60H nozzle tester
2.atomizing quality
3.injecting angle
4.needle valve seals
5.Pressure range:0~60Mpa

PS400A-II Nozzle Tester

>>>>Introduction:

  Nozzle tester is ideal instrument calibrate Injection Pressure, Atomization Quality,Injection Angle and Tightness of the needle

  Its operation is convenient and easy to master.

  Its accuracy is high.

 

>>>>Main technical parameters:

1.     diameter of pressure gauge    150mm

2.     pressure gauge range         0∼60MPa

3.     pressure gauge accuracy rating  0.4

4.     largest tested pressure        60MPa

5.     capacity of fuel tank         1.6L

6.     overall dimension (L×W×H )   250mm×150mm×480mm

7.     net weight                13Kg

8.Bosch S60H 0681200502

Operation:

 Testing of injection pressure of injector assembly Turn the injector assembly tested onto the nozzle joint tightly with high pressure pipe then do the experiment and adjustment of pumping fuel. When pumping fuel, watch the reading on the pressure gauge at the same time,compare it with the specified pressure range of the injector assembly to see if it is normal.If the pressure is too high or too low, adjust the pressure spring of injector assembly.   5.Adjuestment injecting angle. Test the injecting angle ensure the injecting pressure is adjusted.Put a piece of white paper or a piece of iron-wire net painted with grease under the nozzle in the distance.

 

Carton Package with foam:

 

Short Oil Tube(free sparepart):