ITEM

TEST DESCRIPTION

REQUIREMENT

PROCEDURE

Visual Inspection

Refer to

ANSI/EIA-364-18

The inspection results should be compliant with the individual specification.

Before the qualification test, all these components shall be examined the Features, Construction as per applicable specification and documents.

ITEM

TEST DESCRIPTION

REQUIREMENT

PROCEDURE

5-1

Low Level Contact Resistance(Contact):

PIN):Refer to: ANSI/EIA-364-23

50 milliohms max.

Mate connectors:

Measure by dry circuit,

20mV maximum, 10mAmaximum.

5-2

Low Level Contact Resistance(Shell):

Refer t

ANSI/EIA-364-23

50 milliohms max.

Mate connectors:

Measure by open circuit,

5V maximum, 100mAmaximum.

5-3

Insulation Resistance

Refer to

ANSI/EIA-364-21

Method 302 cond. B

100 Mega ohms minimum(unmated)

10 Mega ohms minimum(mated)

Mated connectors, Apply 150Volts DC between adjacent terminal.(500Volts for unmated)

5-4

Dielectric Withstanding Voltage

Refer to

ANSI/EIA-364-20

Method 301

No breakdown.

Unmated connector, apply 500VoltsAC(RMS.) for 1minute between adjacent terminal.

ITEM

TEST DESCRIPTION

REQUIREMENT

PROCEDURE

6-1

Terminal/Housing retention force

0.40kgf/Pin Min.

0.40kgf

Measure the contact retention

6-2

Insertion Force & Withdrawal Force

Refer to

ANSI/EIA-364-13

Insertion Force:4.50kgf Max.

Withdrawal Force:1.00kgf Min.

The specimen is mounted to mounting fixtures by the normal mounting means.The peak force shall be recorded at the maximum rate of 25mm per minute

6-3

Durability

Refer to

ANSI/EIA – 364 – 09

After 10000 cycles test, shall be no

evidence of mechanical or ecectric

defects, and shall meet the

requirements of connector using.

10000 insertion/extraction cycles at a maximum rate of 100±50 cycles per hour.s.