JK-SCR-2P down filling machine automatic weighing and velvet stuffing machine

Temperature:  According to the requirements of BGT14272-2011, the amount of charge test temperature in 20 + 2 degrees celsius.

Humidity:  According to the requirements of GBT14272-2011, the amount of the test humidity in 65 + 4 degrees.

This device is an electromechanical product, Bilateral filling pile structure is composed of touch panel and PLC control the production of dwon clothing and other producs with the filling equipment, can effectively improve the productivity, reduce labor dynamic strength, improve the production environment of factory.

Filling machine features:

1, Two scale alternatiing out of velvet,

2, Down filling with air pressure filling method, does not damae down, can keep down the original soft and elastic and feel.

3, Quantitative and accurate, can choose and set the range of error, effective the contradictory relationship betwwen the filling weight and the filling efficiency.

4, The operation is simple, save labor.

5, Down in the full closure of the equipment cycle, to ensure the production site clean and tidy environment.

6, Good stability, the key components of imported componets.

7, High degree of automation, the whole machine adopts PLC automatic control, full chinese menu operation.

8, High production efficiency, each charge time 1-8 seconds ( as a body weight and weight)

9,  We can according to the customer's product characteristics to provide targeted the solution to completely meet customer demand.

Pressure requirements of the charging machine:

1, Gas supply: 0.8m3/min above.

2, Air pressure: not less than 0.58mpa.

3, Centralized gas supply, requires elss than 20m pipeline distance, pipe track dismeter of not less than 1 inches, if the distance is long, then the phase be hold pipeline gas supply, otherwise, it will cause air is not enough, out of hair is not stable.

4, if the independent gas supply, it is recommended to confiqure 5.5kw above high, the pneumatic pump (0.6~0.8mpa)  and not less than 0.6m3 gas storage tank.

Filling place requirements:

Minimum transport channel: 1M (width) * 2M (height)

Minimum place:  5M (length) * 3M (width) * 2.1M (height)

Recommended place:  6M (length) * 4M (width) * 2.1M (height)