Hair Treatment Operation :       

1. Put the steamer securely on the table, add water and connect to the main power supply.

2. Press the steam ON button. After about 4-5 minutes the water boiled. Press UV light ON button

    when you are ready to steam.

3. Place your head into the cap carefully and adjust the height of your chair appropriately

4. Do not cover your head below forehead.

5. You may adjust the hot temperature by adjust the hole at the top of steam head.

6. Turn off the unit after usage. Normally 5-15 minutes treatment would be enough.

Facial Treatment Operation:                             

1.  Put the steamer securely on the table, add water and connect to the main power supply.

2.  Rotate the spray pipe to a comfortable angle.

3.  Dip some aroma by tampon then put it into the aroma hole. (as you like)

4.  Press the steam ON button. After about 4-5 minutes the water boiled. Press UV light ON button

      when you are ready to steam.

5.  Begin facial treatment.

6.  Remember the safety distance is 30-50cm from the spray hole, so that your face won’t get too hot.

7.  Normally 5-15 minutes treatment would be enough, 3-5 minutes for sensitive skin. Maximum O3

      sterilizing is 5 minutes.

8.  When treatment has finished turn off appliance.

Safety function:                            

The 2 in 1 facial & hair steamer is with good safety function. When the water level is too high or too low,

it will automatically stop working. After adding or reducing water, you should restart the unit for reworking.

You won’t worry about too much hot water spit out causing injury or too little water which damages the unit.