China Supplier cell phone signal booster amplifier repeater,3G 4G Ite repeater
USD $1 - $999 /Set
Min.Order:1 Set
Quanzhou Kingtone Optics & Electronics Technology Co., Ltd.
900 1800 2100 tri band repeater, 900 1800 2100 repeater, tri band mobile signal repeater
rural area cell phone repeater, wide area mobile signal repeater, outdoor repeater
multi band repeater, cell signal booster 4g LTE 3g 4g repeater, cellphone booster
2w dual band repeater wireless cellphone repeater mobile signal repeater
High gain WCDMA 2100 3g ICS pico repeater amplifier for home and office coverage
Kingtone 2016 cell GSM WCDMA 2G 3G repeater and mobile signal booster
China Supplier cell phone signal booster amplifier repeater,3G 4G Ite repeater
Main Features
1. High linearity PA; High system gain;
2. Intelligent ALC technology;
3.Full duplex and high isolation from uplink to downlink;
4. Automatic Operation convenient operation;
5. Integrated technique with reliable performance;
6. Bandwidth can be configured from 0.2-25MHz in work band.
7.Local and remote monitoring (optional) with automatic fault alarm &remote control;
8. Weatherproof design for all weather installation;
cell phone signal booster amplifier repeater,3G 4G Ite repeater
GSM900 repeater Specification
Donor Specification
Items | Testing Condition | Specification | ||
Uplink | Downlink | |||
Working Frequency(MHz) | Nominal Frequency | 3g 4g | 3g 4g | |
Frequency Range(MHz) | Nominal Frequency | 1.5G or 1.8G | ||
Gain(dB) | Nominal Output Power-5dB | 50±3(Station Couple) | ||
>80(Air Receive) | ||||
Output Power (dBm) | GSM modulating signal | 0(Station Couple) | 37 | |
33(Air Receive) | 37 | |||
ALC (dBm) | Input Signal add 20dB | Po≤±1 | ||
Noise Figure (dB) | Working in-band(Max. Gain) | ≤5 | ||
Ripple in-band (dB) | Nominal Output Power -5dB | ≤3 | ||
Frequency Tolerance (ppm) | Nominal Output Power | ≤0.05 | ||
Time Delay (us) | Working in-band | ≤5 | ||
Peak Phase Error(°) | Working in-band | ≤20 | ||
RMS Phase Error (°) | Working in-band | ≤5 | ||
Gain Adjustment Step (dB) | Nominal Output Power -5dB | 1dB | ||
Gain Adjustment Range(dB) | Nominal Output Power -5dB | ≥30 | ||
Gain Adjustable Linear(dB) | 10dB | Nominal Output Power -5dB | ±1.0 | |
20dB | Nominal Output Power -5dB | ±1.0 | ||
30dB | Nominal Output Power -5dB | ±1.5 | ||
Inter-modulation Attenuation (dBc) | Working in-band | ≤-45 | ||
Spurious Emission(dBm) | 9kHz-1GHz | BW:30KHz | ≤-36 | ≤-36 |
1GHz-12.75GHz | BW:30KHz | ≤-30 | ≤-30 | |
VSWR | BS/MS Port | 1.5 | ||
I/O Port | N-Female | |||
Impedance | 50ohm | |||
Operating Temperature | -25°C ~+55°C | |||
Relative Humidity | Max. 95% | |||
MTBF | Min. 100000 hours | |||
Power Supply | DC-48V/AC220V(50Hz)/AC110V(60Hz)( ±15%) | |||
Remote Monitoring Function | Real-time alarm for Door Status, Temperature, Power Supply, VSWR, Output Power | |||
Remote Control Module | RS232 or RJ45 + Wireless Modem + Chargeable Li-ion Battery |
Remote Unit Specification
Items | Testing Condition | Specification | ||
Uplink | Downlink | |||
Working Frequency(MHz) | Nominal Frequency | 3g 4g | 3g 4g | |
Frequency Range(MHz) | Nominal Frequency | 1.5G or 1.8G | ||
Gain(dB) | Nominal Output Power-5dB | 95±3 | ||
Output Power (dBm) | GSM modulating signal | 37 | 40 | |
ALC (dBm) | Input Signal add 20dB | Po≤±1 | ||
Noise Figure (dB) | Working in-band(Max. Gain) | ≤5 | ||
Ripple in-band (dB) | Nominal Output Power -5dB | ≤3 | ||
Frequency Tolerance (ppm) | Nominal Output Power | ≤0.05 | ||
Time Delay (us) | Working in-band | ≤5 | ||
Peak Phase Error(°) | Working in-band | ≤20 | ||
RMS Phase Error (°) | Working in-band | ≤5 | ||
Gain Adjustment Step (dB) | Nominal Output Power -5dB | 1dB | ||
Gain Adjustment Range(dB) | Nominal Output Power -5dB | ≥30 | ||
Gain Adjustable Linear(dB) | 10dB | Nominal Output Power -5dB | ±1.0 | |
20dB | Nominal Output Power -5dB | ±1.0 | ||
30dB | Nominal Output Power -5dB | ±1.5 | ||
Inter-modulation Attenuation (dBc) | Working in-band | ≤-45 | ||
Spurious Emission(dBm) | 9kHz-1GHz | BW:30KHz | ≤-36 | ≤-36 |
1GHz-12.75GHz | BW:30KHz | ≤-30 | ≤-30 | |
VSWR | BS/MS Port | 1.5 | ||
I/O Port | N-Female | |||
Impedance | 50ohm | |||
Operating Temperature | -25°C ~+55°C | |||
Relative Humidity | Max. 95% | |||
MTBF | Min. 100000 hours | |||
Power Supply | DC-48V/AC220V(50Hz)/AC110V(60Hz)( ±15%) | |||
Remote Monitoring Function | Real-time alarm for Door Status, Temperature, Power Supply, VSWR, Output Power | |||
Remote Control Module | RS232 or RJ45 + Wireless Modem + Chargeable Li-ion Battery |
cell phone signal booster amplifier repeater,3G 4G Ite repeater
cell phone signal booster amplifier repeater,3G 4G Ite repeater
cell phone signal booster amplifier repeater,3G 4G Ite repeater is designed to solve problems of weak mobile signal, which is much cheaper than adding a new Base Station (BTS). Main operation of RF Repeaters system is to receive low power signal from BTS via radio frequency transmission and then transmit the amplified signal to the areas where network coverage is inadequate. And the mobile signal is also amplified and transmitted to the BTS via the opposite direction.
cell phone signal booster amplifier repeater,3G 4G Ite repeater
To expand signal coverage of fill signal blind area where signal is weak or unavailable.
Outdoor: Airports, Tourism Regions, Golf Courses, Tunnels, Factories, Mining Districts, Villages etc.
Indoor: Hotels, Exhibition Centers, Basements, Shopping Malls, Offices, Packing Lots, hospital etc.
It is mainly applicable to such case:
The repeater can find an installation place which can receive pure BTS signal at strong enough level as the Rx Level in repeater site should be more than -70dBm;
And can meet the requirement of antenna isolation to avoid self-oscillation.
Kingtone
Kingtone was established in 2006, located in Microwave Communication Base of the National Torch Plan in Quanzhou, China. It is a leading manufactory specializing in wireless network communication equipment and dedicated to R&D,manufacture,salses and services of microwave mixture IC, microwave function components, softwares of radio stations, communication monitoring and internetwork products.
Kingtone pays special attention to R&D, innovation, quality system and brand building. We have achieved seven software copyright certificates registered by the State Copyright Bureau and passed the ISO9001:2008 quality management system. Four Bands have been registered by the State Trademark Bureau and we have been recognized as "innovative and high technology enterprises " by Fujian Science and Technology Department in 2010. Our products are widely used in mobile communication, radio and television, public security, fire control, railways, electric power, mining and other fields; the main products are GSM repeater, CDMA repeater, CDMA450 repeater, IDEN repeater, TETRA repeater ,DCS repeater, PCS repeater, PHS repeater, TD-SCDMA repeater, WCDMA repeater, FDD-LTE repeater,TDD-LTE repeater,WiMAX repeater, MMDS repeater,MUDS repeater, digital TV repeater, cluster 450 M,350 M.and other standards’ repeaters simulation, digital mobile communication repeaters and its functional components.
Kingtone insists on the spirit of “people-oriented, technology first, unity and strive, innovation and dedication” and the quality concept of “golden quality win the world” to continuously provide superior quality products and services to our customers.
We are sincerely willing to cooperate with you. let’s win the future together!
Since 2006,Kingtone has been developing and manufacturing Repeaters including CDMA,GSM,DCS,PCS,UMTS(W-CDMA).Tetra,IDEN,Wimax and LTE ec.Moreover,Kingtone repeater have different types included Band-selective,Channel-selective,Frequency-shifting,Fiber-optical,Trunk-amplifier single and multiple bands for different mobile operators.As well as the repeater,the passive circuits such as Splitters,Couplers,POI,Connectors,Antennas are in operation.
At present,Kingtone exhibited the highest quality products and enterprise's comprehensive strength,and Kingtone continues to strengthen technological innovation on repeater products and will launch the new products on the market soon.With your supports and new requirements which can make us improve our service,innovative our technology and consummate the products.
Product range:GSM/CDMA/DCS/WCDMA/TETRA/LTE Wireless Full Band Repeater,Fiber Optic Repeater,Frequency Shifting Repeater,Digital/Analog Repeater,Trunk Amplifier etc
Support System | Frequency Range | Output Power |
GSM900MHZ | 890-915MHz/935-960MHz | 2W/5W/10W/20W/30W/40W/50W/60W |
DCS1800MHz | 1710-1785MHz/1805-1880MHz | 2W/5W/10W/20W/30W/40W/50W/60W |
PCS1900MHz | 1895-1910MHz/1975-1990MHz | 2W/5W/10W/20W/30W/40W/50W/60W |
GSM850MHz | 824-849MHz/869-894MHz | 2W/5W/10W/20W/30W/40W/50W/60W |
CDMA450MHz | 450-457.5MHz/460-467.5MHz | 2W/5W/10W/20W/30W/40W/50W/60W |
CDMA800MHz | 824-849MHz/869-894MHz | 2W/5W/10W/20W/30W/40W/50W/60W |
CDMA1900MHz | 1880-1890MHz/1960-1970MHz | 2W/5W/10W/20W/30W/40W/50W/60W |
UMTS850MHz | 824-849MHz/869-894MHz | 2W/5W/10W/20W/30W/40W/50W/60W |
UMTS2100MHz | 1920-1980MHz/2110-2170MHz | 2W/5W/10W/20W/30W/40W/50W/60W |
GSM900/1800MHZ | 890-915MHz/935-960MHz 1710-1785MHz/1805-1880MHz | 2W/5W/10W/20W/ |
GSM850/1900MHZ | 824-849MHz/869-894MHz 1880-1890MHz/1960-1970MHz | 2W/5W/10W/20W |
GSM900/UMTS2100 | 890-915MHz/935-960MHz 1920-1980MHz/2110-2170MHz | 2W/5W/10W/20W/ |
Packaging Details: | Single Band Repeater: Dual band Repeater: 2w: 38kg 5w: 40kg 10w: 42kg 20w: 44kg Triple band repeater: 2w: 42kg 5w: 46kg
|