The Cross-Plate anchor is made for installation in holes drilled by power diggers.
Because the size of the hole does not affect holding capacity, the hole can be dug by the same auger that is used to dig the pole holes on transmission projects.
Cross-Plate anchors are installed in a diagonal bored hole which is undercut so the anchor is at right angles to the guy.
A rod trench is either cut with a trenching tool or drilled with a small power auger. Both anchor and rod trench should be refilled and tamped.
Features:
Cross plate anchors are made for installation in holes augered by power drillers.
One piece plate anchor formed of two structureal members that are ribbed for reinforcement.
A retainer on the bottom holds the nut from the forged eye rod (sold separately).
The product can be done according to your size.
.