12V portable auto jump starter (SPB5001)

Overview photos 

1.Over-charging protection    Over-current protection      Short-circuit protection  Over-discharging protection   voltage stabilizing

2. Full set of accessories:

Product Specifications:

Parts List:

Operation:
1, Select the appropriate voltage and connector for the electronic device to charge / power supply
2, Press the switch to start charging when your device connected with SPB5003; If you unplug the cable, auto-sleep will start

    in one minute.
3, Five lights will flash circularly during the charging by SPB5003 and all lights will keep bright when your device is full-charged
4, During the charging for your device, LED lights indicate the balance power of built-in battery of SPB5003. Four lights

     indicate 80% balance, three lights indicate 60% balance, two lights indicate 40% balance and one light indicates 20%  

     balance. The built-in battery is empty whenall LED lights start to flash

5, Press the switch three seconds to start If you want to use LED for illumination and select the status ( light, burst flashing, 

    SOS, close) by pressing the switch to transform.

6, Store the product in a cool and dry place and away direct sunlight.

Matters need attention:
To start 12V vehicle, please make sure at least three LED lights of SPB5003 are bright firstly, then connect the Red battery clamp to the battery Positive (+) and Black clamp to the battery Negative (-) and insert the plug into the EPOWER, finally turn the ignition switch to the START position. Once the vehicle is started, please disconnect the plug and remove the battery clamps within 30s.

Product advantage:
1. Use high power polymer cells, fast charging and low self-discharge, cycles can reach 1000 times.
2. Support 12V vehicle for emergency start, portable illumination and various mobile phone, PSP, MP3/MP4 Pocket PC PDA

    as well as other products charge / power supply;

Terms & Conditions

 Other mini car jump starters: