Installation of Adhesive Weights:

Pre-treating the rim:

Clean the rim thoroughly with a cleaning agent that is compatible with varnish(e.g. IPA 70%) in order to remove any residual grease, silicone or adhesive.

Please note: A minimum of 15℃ is required in terms of both the room temperature and the rim temperature.

Pre-bending the weights:

Separate the correct gram(as calculated) from the bar. Mould the shape of the weight to match the rim radius(with protective film).

Please note: You need to bend the weights gradually, otherwise they will break apart at the joins. You should bend the weight to a little more than the rim's radius.

Removal of the protective film:

Remove the protective film.

Please note: Do not touch the glued surface after peeling off the rim.

Sticking the weight on:

Attached the weight to the calculated point on the rim, making sure that the weight is distributed evenly either side and the weight is parallel with the edge of the rim.

Please note: Press down on the weight hard, working from the centre to the left and right. A minimum pressure of 1kg/cm2 is required. The angle of the sticking surface should not be higher than 15 ℃ to normal.

Points:

  1. Professional balance weight MANUFACTURER

  2. Strong self-adhesive tape

  3. Compressive strength testing

  4. Lead free, environmental friendly.

  5. Customized design are welcomed

  6. ISO9001:2008 quality management system certification.

NOTE: When you send us inquiry letter , kindly pls include the following information if possible:

Part No.:

Qty:

Any detailed requirements!

It will help us reply to you efficiently. Thank you.

Samples are avaliable to send.

Don't miss the opportunity to check our full range of tire repair products. 

HOPSON TYRE REPAIR will always surprise you! 

HOPSON TYRE REPAIR @ automechanika Frankfurt 2014