Specifications

Ball valve used as manual tank or filter drain
Solid state adjustable with test button
Valve design allo

Tank Drain Features:

 

•          Built in strainer
•          1/4 turn ball valve
•          Dual size inlet
•          Large 4mm internal orifice
•          Internal armature and shaft made from stainless steel
•          Unique Mounting system
•          Dual internal drain ports
•          Ball valve used as manual tank or filter drain
•          Solid state adjustable with test button
•          Valve design allows for disassembly

 

Tank Drain Specifications:

 

•          Timer: Solid-state construction
•          Status Indication: Power "ON"
•          Valve"OPEN"
•          Internal Time: 0.5 to 45 min. (as required)
•          Discharge Time: 0.5 to 10 sec. (as required)
•          Electrical Connection: DIN 46242
•          Connector: 4-position connector
•          Coil: 110/115 volt AC(standard)
•          Available 12 volt/24 volt DC, 220/230 volt AC for overseas installations
•          Insulation: Class H 180°C (350°F)
•          Protection: IP65 including connector
•          Conforms to NEMA 4 std.
•          Temperature Range: -20°C (-4F) to +150°C (300°F)
•          Standard Voltages: 220/240V, 50Hz 115V, 60Hz
•          Valve: 2-wy normally closed
•          Pressure Range: 0 to 16 bar (230 psi g
•          Temperature Range: Ambient: -10°C (14°F) to +50°C (120°F)
•          Fluid: -10°C (14°F) to +140°C (285°F)
•          Lubrication: Not required
•          Strainer: Stainless steel screen ON/OFF control for self-cleaning
•          Media: Air, gases, water, oil etc.
•          Construction Materials: Tube/plunger - AISI 300/400 Spring - AISI 18/8
•          Body: Brass
•          Seal Material: Buna
•          Typical Installations: Compressor Source
•          Receiver Outlet
•          Filter Outlet