Product Details

Golden Supplier New 6mm tempered glass sheet

Tempered/Toughened glass is produced by heating to a softening point in a specific mold and equipment. The glass is rapidly cooled with jets of cold air, including compressive stress to the surface while the center remains tensile.

Features

1. Safety: if breakage occurs the glass breaks up into small, cubical fragements, which are not threatening to human.

2. Stronger resistance to thermal breakage than annealed or heat strengthened glass

3.4-5 times stronger than annealed glass of the same thickness.

4. It withstands abrupt temperature change of 220°C.

5. Sizes are produced per customer request, once tempered, cannot be cut down

Specification

Brand	HuaYe Glass
Thickness:	3-19mm
Color:	Clear, ultra clear, Ford blue, F green, Grey Etc
Max size	24406000 & 28505000
Min Curved Radius:	1000mm(Thinckness:5~6mm) 1200mm(Thickness:8~12mm) 2000mm(Thickness:15~19mm)
Applications	Facades and curtain walls Sightseeing elevator channels Day lighting ceiling Glass railing and balustrade, handrail Windows and doors Pool fence Glass partitions Balcony Canopy Shower enclosures
Standard/Certificate	China GB15763.2-2005,Europe EN12150-2-2004, and AU AS/NZS 2208:1996, ANSI Z97.1 and CPSC 16 CFR 1201 CCC, CE, CSI,SGCC
Edging choice	Seamed: A seamed edge has been sanded and it may be rough and slightly chipped, but it will not be sharp. It is the most economical edge but it's not recommended if the edges will be exposed. Flat Polish: As the name implies, a flat polish is a flat edge with a small 45 degree chamfer on the very top and bottom with perfectly polished sides.
Corner choice	Sharp Corner: none finish, not as safe to handle. Suitable for 6mm and below glass thickness Dubbed corner: refer to the process of slightly sanding down the corner edges so they are not so sharp. It is a common safety measure for glass table tops, glass table covers and glass desk covers. Radius corner: the glass corners are cut with a radius to form a curved outer edge instead of a sharp angle. This will incur an additional fee. Suitable for 12mm and above glass thickness
Drilling and Notching according to customer's requirements