Specifications

connected to an electrical pump through an electrical cable , is used for the auto-control and no-water protection of the water

The device connected to an electrical pump through an electrical cable , is used for the auto-control and no-water protection of the water tower and water pool .

Performance and characteristics

Simple construction, reliable performance

The product can output stable and reliable switch control signal of"

making"," breaking"without any fault action, so its eliability is very high

and antiinter-ference is strong.

Sturdy and durable, need not maintain

The product can be used for a long time after it being installed. Almostno maintenance and repairing problem would occur during its operation period.

Easy installation method, convenient adjustment method

The liquid level control scope can be adjusted at will with the locating

piece moving up and down .Only one screw is needed to secure the signal

cableto finish installation.                      

Wide application scope, strong generality

The product applies to branch water, sewage acid-base solution of

less than medium concentration, oils and situations requiring no pollution

(for example food and drinks industry), diesel oil gasification kitchen range,

and automatic fuel feeding

Simple circuit. economial and practical

Operation voltage is 200V,and current can be up to 10A,The applied

circuit of the product is simple, so application costis very low.

 

Instructions for installation

May be used for direct level contro 1.In accordance with product electrical specifications. In the case of approved products,the ground wire will always be included and the ground wire sheath will always be yellow/green.In this case,this two remaining wires are supplied for “high closure” or specific request”low closure”