Electric jack 12V DC Electric jack Off-road vehicle with an jack

Specifications

Product Features

Products through the German GS certification standards, carrying the weight reached 1:1.25 times dynamic and static reach 1:1.5 times, tested, enough to withstand the weight of 1500Kg.
Overload protection function: When the weight exceeds the rated load automatically when you stop working to protect the product from damage and operator safety.
High quality four-pole brushless 12V DC motor, torque, strong, powerful, compared to similar products using the two-pole brushless DC motor than double the life!
Electric jack on the top block of high strength nylon 66 material, tough anti-slip, effectively preventing the car surface paint scratches
Superior to the majority of members to recommend a practical driving equipment - car electric jack!!!
In real life, the replacement of car tires has been driving people a headache, especially in the wild side of the road, in the hot summer, cold winter and a drizzle of weather conditions, with a hand-cranked (mechanical) jack to change a tire is very time-consuming, laborious, individual gentlemen, there is no strength to be able to top up the car every time tired sweaty and covered in sludge.

Instructions for use
1, the use of electric jin items:
 to park your car on a level surface, turn off the engine, but do not forget to tighten the hand brake.
 the electric jack to change a tire was placed under the car near the steel beams, and slide the top cap electric jack beneath the body aligned anchor, electric jack can do so safely and effectively lifting.
 Use the cigarette lighter connection: Connect the cigarette lighter plug cord into the cigarette lighter socket and the other end of the 5.5mm plug to 5.5mm plug on electric jacks seat. (Note: The cigarette lighter fuse rated current not less than 10A)
 Use the vehicle's battery direct connection: the cigarette lighter plug cord into the battery clamp with cigarette lighter socket at one end while the other end of the red battery clip to clip the battery "+" (positive), the black clip and battery "-" (negative), and then plug the other end of the cigarette lighter plug cable 5.5mm plug to 5.5mm plug on electric jack socket.buttons on the remote controller is pressed, "^" represents up, "^" for down, "." means stop. )the jacking process, should be carefully observed jacking dynamic, not tilted to ensure electric jack until the wheels leave the ground 20mm, the wheels can rotate freely should stop lifting, replacing tires.

2, the use of electric wrench: When replacing the wheels off the ground, it will take a good supply of electric wrench (the electric wrench 5.5mm power plug directly into the cigarette lighter plug cord 5.5mm plug seat).
 selecting the right sleeve, the sleeve into the square hole at the top of the square shaft electric wrench head to loosen or tighten the bolts.
 the desired direction of the work, choose loose, tight switch. The power switch on the left flag "|", was the reverse direction, the right flag "|", was the clockwise direction, the middle mark ".", was the stop. Press and hold the corresponding direction with the thumb switch, heard 1-2 times "despair, despair" crash immediately after releasing the thumb, the whole process takes about 2-3 seconds.