BEST PRODUCTS WITH CHEAPER PRICE IS OUR GUARANTEE !

DD862 electromechanical Three Phase or single Phase Energy Meter with bakelite cover and bakelite base for iraq market

Product Brief Introduction

The DD862 type single-phase watt-hour meter is a kind of induction type meter whichis applicable to measure the rated frequency 50Hz and power loss in electrified-wire netting.The meter has novel design,rationalstructure and features ofhigh over-Ioad low power IOS5 and long life etc.AII technical targets are completely conformed to the stipulated requirement of NationalStandard GB/T15283-94 Class 0.5,1 and 2 AC Active Watt-hour Meter and International StandardIEC60521.

Product Detail

Specifications

meet the latest IEC62053-21,IEC62052-11 standards

measuring active energy in three-phase four-wire

The DT862 three-phase fore-wire meter is designed to meet the latest IEC62053-21,IEC62052-11 standards for measuring active energy in three-phase four-wire alternating current power grids. Connection is direct or by instrument transformers. The meter is KEMA certified. It has an average service life(MTTF)of 20 years and maximum overload capacity of 600%Ib.

Construction

Meter case

It meets the protection requirements set by protection class IP53 of IEC62053-21. The series types of cases and terminal covers are available.

Terminals

The connection terminals are made for nickel-plated brass with features of high mechanical Strength, good conductivity and corrosion-resistance.

Terminal block

The terminal block is injection molded of heat-and fire-resistant Bakelite . The voltage test link can be located inside or outside of the meter case.

Driving system

The driving system employs three single electromagnet elements, all of which are mounted on the meter frame with three screws. Each electromagnet element consists of voltage element, current element and connection board. In addition, the voltage electromagnet has low load and inductive load adjustment mechanisms. The current element employs a simple and reliable load curve compensation mechanism to ensure the flat characteristic curve.

Rotor

The rotor shaft is turned of high strength aluminum alloy. The upper end of the shaft is pressed with a worm which is made of thermoplastic, and the lower end is embedded with a graphite bearing which is self-lubricative and friction-resistant to ensure long service life of the meter.

Braking element

The magnet is made of AINiCo5 alloy and designed as U-shaped so that the effect of short-time over currents upon the magnet is negligible. A temperature compensation plate, made of a special alloy, is embedded in the braking magnet. The rotor speed can be adjusted largely and continuously by rotating the whole magnet.

Frame

The frame is die-casted by high quality Si Al alloy. Its structure is designed as W-shaped of stable property to avoid distortion, and its surface is treated with chromate to achieve reliable and durable coating against oxidation.

Upper bearing

The pin is made of abrasion-proof stainless steel, and pressed into the brass sleeve. It is the rotor guide and runs in the plastic worm of the rotor.

Lower bearing

The magnetic suspension bearing consists of two ring shaped magnets, a guide pin and a bearing base. The pin made of stainless steel runs in the graphite sleeve of the rotor. No lubrication is needed.

Register

The cyclometer type register consists of six drums. It can be read directly. The drum is made of polycarbonate. The framework is embedded with a high-strength self-lubricating plastic bearing. No lubrication of bearings is needed during the service life.

Series Products

AMI System

All of our energy meters can match with AMI systems.Aout more details,pls contact me.

Certificates

Package & Delivery

Company Information

Our Services

1. Any question from you are welcome and will be replied in 24 hours.

2. The reasonable price.

3.Answer your question detailed.

4.Solved the problem with you during using our products.

5.Samples will be offered to you for our future cooperation.