Specifications

Mechanical filter
Effective treatment ,Economical investment ,automatic operation .small occupy

 

working principle:

 

 

 

1.By the entrance into the water, the first after thick mesh filter out larger particles, and then reach fine mesh impurities. In the filtering process, fine mesh gradually accumulated dirt and impurities in water, forming filtering impurities layer, because impurities accumulated in fine of filter layer, so in fine mesh medial side of internal and external form one differential pressure.
When filter pressure differential achieve default value, will begin to automatic cleaning process, during which no depletion, water supplies, clean room cleaning valves open and absorbing unclean device for internal pressure dropped substantially, suction filter canister and dirt by the pressure difference and suction pipe tube and rinsing room dirt between produced by suction nozzle, forming a suck a suction decontamination process. Meanwhile, electric motor drive sucked unclean tube along the axial do spiral movement. Suck unclean device axial movement and the combination of rotation movement within the entire mesh surface completely clean. The whole flushing process just tens of seconds. Drain valve closes in cleaning end. Filter began to prepare for the next flush cycle.

 

 

 

 

 

2. Processed by the water, the water enters the water entry in stainless steel mesh impurities deposition, the resulting differential pressure. Through the differential pressure switch monitoring in shuikou differential pressure changes, when the pressure difference control device to set value, to our hydraulic control valves, drive motor signals, cause the following actions: motor driving brushes spin, cleaning, and at the same time to filter for drainage, the control valve opened the cleaning process just continued dozens of seconds, when cleaning, shut off the valve end, motor stop, the system restore to its initial condition, began to enter the next filtration process.
Equipment installation, debugging by technicians, setting filtering time and cleaning conversion time, processed by the water enters the water entry, a filter began to work normally, when they reach the preset cleaning time, electric control device for hydraulic control valves, drive motor signals, cause the following actions: motor driving brushes spin, cleaning, and at the same time to filter for drainage, the control valve opened the cleaning process just continued dozens of seconds, when cleaning, shut off the valve end, motor stop, the system restore to its initial condition, began to enter the next filtration process.

 

 Main Parameter:

NO.	ITEM	Description
1	Housing material	CS, FRP or SS
2	Shell body thickness (mm)	8
3	Head thickness   (mm)	10
4	Nozzle plate thickness     (mm)	10
5	Filtering cap number	36pcs
6	Inner surface	rubber lining/epoxy resin for internal protection
7	Outside surface	both undercoat and finishing coat is painted twice
8	Media material	Quartz sand
9	Capacity	18m­3/h
10	Function	pre-treatment for various water equipment/effectively remove chlorine, organic, colloid, etc
11	Back washing	manual
12	Connection	series connection
13	Speed (m/h)	8-12
14	Height of Filter layer(mm)	1000
15	Under layer thickness (mm)	200-400
16	Dimension(mm)	1500X3000
17	Dia. of outlet &inlet (mm)	DN80
18	Backwash capacity	9-15L/s•m2
19	Water inlet pressure	≥0.04Mpa
20	Backwash inflow water pressure	≥0.15Mpa
21	working pressure	≤0.6Mpa
22	Working temperature	5°C~50°C(special temperature can customized)
23	Total weight	3100kgs/2700kgs/2950kgs
24	Sand dosage	2200kgs