High quality preformed suspension clamp
USD $15 - $80 /Set
Min.Order:1000 Sets
Shandong Haihong Electric Power Equipment Co., Ltd.
High quality preformed suspension clamp / dead end clamp for ADSS cable:
High quality preformed suspension clamp / dead end clamp for ADSS cable:
Composition: Inner twisted wire,Outer twisted wire,Rubber block and cast aluminum shell.
Use:To play a supportive role, the optical fiber composite overhead ground wire (OPGW) are
hung on a straight line on the tower.
Features:
a. Suspension and OPGW cable has a larger contact area, stress distribution uniform, no stress
concentration points, play better on cable protection, at the same time enhancing the stiffness
of cables at hanging point location.
b.There is a good dynamic stress capacity, can provide sufficient grip strength (14 ~ 18% RTS) in order
to maintain OPGW cables in the long run under the conditions of unbalanced load for safe operation.
c. Suspension of overhanging angle to meet the 15 ° ~ 18 °
d. The structure coupled with flexible rubber clip block, enhanced self-damping to reduce abrasion.
e. Rounded end processing, increased corona voltage.
f. high-quality aluminum alloy material to enhance the mechanical properties of the clamp and corrosion
resistance, significantly extended service life.
Order Notes:
1. According to the diameter of OPGW cable parameters such as selection of suitable Suspension.
2 . the number of configurations as follows: 1 set / line tower.
3. The lay direction of inner twisted wire is opposite with lay direction of the outer twist wire, the standard
configuration: Lay direction for OPGW outer twisted wire is right, If left, it should be specified in the order
contract.
4. According the mount point on the tower, select the appropriate link fittings (such as the U-screws, U-type
hanging ring, UB clevis etc.).
5. Clamp Strength is divided into 70KN, 100KN , 120KN and so on.