Specifications

1.cap mould
2.hot runner mold
3.16 cavities
4.material of P20 and 2316

 

Brief Introduction

• keep 500°C about 36 hours in vacuum station to eliminate the stress, make sure the molding board steady after long time use.
• Slipper block use HUSKY type, with material of steel P20, which is highly anticorrosion, all the move parts used advanced ion nitrating treatment, the surface hardness is HRC48-52.

 

              

 Spare parts(screw, coin and cavity)

All uses material steel 2316, with high anticorrosion and hardness is HRC46-48.

 

 

Hot Runner: use SKH61 temperature resistance material, with hardness HRC≥46

 

 

 

 

 

 

 

• The hot nozzle use Italy ROTFIL or German HOTSET heating coil to make sure the quality.
• Plastic injection opening use high hardness QBE2 Beryllium copper, with good conduct heat, anti wear and standy.
• Plastic injection opening heat insulation cap use American Dupont.
• Piston and cylinder use import wear ring, the piston use material 2136, the sealing element used import sealing element, with materialof poly four vinyl chloride.