Iec60335 Iec60598 Creepage Distance Test Card With Precision Slip Gauges

Key words: metal feeler gauge, measuring & gauging tools,  reepage ruler, Creepage caliper

1.Basic introduction

• For gauging  the creepage and clearance distances in dead state between parts under voltage in the operating conditions as well as between touchable metal pieces and parts under voltage in the operating conditions. e. g. in installation material, switchgears, plugs, socket-outlets and electric appliances
  according to IEC and CEE Publications,EN Standards,VDE Specifications.
• It is used to determine the shortest path between two conductive parts, or between a conductive part and the bounding surface of the equipment, measured along the surface of the insulation, with specifications made according to the requirements.
• Creepage distance test card or feeler gauge is made of whole stainless steel.

2.Dimensions:

• CX-PD10	1.0/2.0/2.5/2.8/3.2/3.6/4.0/5.0/5.6/6.3mm
  CX-PD30	1/1.05/1.1/1.2/1.25/1.3/1.4/1.5/1.6/1.7/1.8/1.9/2.0/2.1/2.2/2.4/2.5/2.8/3.2/ 3.6/4.0/4.2/4.5/5.0/5.6/6.3/7.1/8.0/9.0/10mm
  Standards	IEC60598 IEC60335 IEC60601 IEC60065
  Customized size are offered.

   

•   Creepage Distance Gauges for gauging the creepage and clearance distances in dead state between parts under voltage in the operating conditions as well as between touchable metal pieces and parts under voltage in the operating conditions e. g. in installation material, switchgears, plugs, socket-outlets and electric appliances
  according to IEC and CEE Publications,EN Standards,VDE Specification

• Picture of CX-PD10

• 

• CX-PD30

• 

• Standards:

  1 gauge block, cross section approx. 1 mm x 1 mm, distances between measuring
  faces by agreement from 1 mm to 8 mm with a tolerance of -0.02 mm,
  with shaft, cross section approx. 2 mm x 1 mm,
  and with grip, approx. 12 mm x 40 mm x 1 mm,
  rounded, with bore and engraving
  (distance / mm, e. g. "5,0").

   

  Design: made of spring steel, hardened and browned, measuring faces ground plane
  parallel, total length approx. 70 mm,

   

  with XY = distance between measuring faces in 1/10 mm. Example: the article no. of the
  creepage distance gauge having a distance between measuring faces of 3,5 mm

  Assotments :

  Creepage Distance Gauges Bunch A

  with 8 creepage distance gauges:
  1,0 - 1,5 - 2,0 - 2,5 - 3,0 - 4,0 - 6,0 - 8,0 mm,

   

  Creepage Distance Gauges Bunch B
  with 15 creepage distance gauges:
  1,0 to 8,0 mm in steps of 0,5 mm,

   

  In some publications, standards and specifications, there are distances to be gauged,
  which are beyond the distance range chosen for  creepage distance gauges. To
  gauge distances below 1 mm, we recommend to use feeler gauges.