Product Features:

 automatic induction: to enter the sensing range of the output is high, people leave the sensing range is automatically delay off high, output low.
 You can achieve a small signal control large loads.
 photosensitive control (optional, not factory set): You can set photosensitive control, day or light intensity without induction.
 Temperature compensation (optional, not factory set): In the summer when the ambient temperature rises to 30 ~ 32 °C, detection distance is slightly shorter, temperature compensation can be used for certain performance compensation.
 Two trigger modes: (jumper selectable)
   a. unrepeatable trigger: the sensor output high, the delay time is over, the output automatically from high to low;.
   b. repeatable trigger: the sensor output high, the delay period, if there is human activity in its sensing range, the output will remain high until after the delay to leave the high-power level goes low (sensor module detects the human body every activity will be automatically extended after a delay time period, and the final event of the starting point of delay time).
 with induction blocking time (default setting: 2.5S block time): sensor module output every time after induction (high into low), can be followed by a blockade set period of time, during this time period induction does not accept any sensor signal. This function can be achieved "sensor output time" and "blocking time" interval between the work can be applied to interval detection products; while this feature can effectively inhibit the load switching process produces various kinds of interference. (This time can be set to zero seconds - tens of seconds).

Applications:

 Human body induction lamp induction toys
 Industrial automation and control security products
Auto-sensing electrical equipment  Battery powered automatic control

Technical parameters:

Working voltage DC 12V (default), other 5V, 24V can be customized
Quiescent Current <60uA
Relay Output VCC output (default) other normally open, normally closed switch can be customized
Relay output Maximum current 3A (default) Others can be customized
Trigger L unrepeatable trigger / H repeatable trigger (default)
Delay time 5S (default) other can be customized according to the customer
Blocking time 2.5S (default) other customized according to customer
PCB Dimensions 39mm * 34mm
Induction angle <110 ° cone angle
Sensing distance of 7 meters
Operating temperature -20 - +80 degrees
Induction Lens Diameter: 23mm (default)

Caution Note:

 sensor module powered a minute or so after the initial time interval during which the module outputs 0-3 times, one minute after entering the normal standby state.
 Installation should try to avoid direct lighting and other interference sources close to the lens surface of the module, in order to avoid introducing interference signal malfunction; avoid the use of environmental flow of the wind, the wind sensor will also cause interference.
 installation should pay attention to the direction of the angle, or affect the sensing distance. When installing a square window on the probe module and human activities as much as possible in the direction parallel to a maximum, so that the induced effect was to achieve better results.
 In use, when the ambient temperature rises close to the surface temperature of the human body (30 ~ 32 °C), detection range will be slightly shorter, this is the result of a temperature-factors.