wifi signal repeater waterproof outdoor 5W wifi repeater
Operating frequency | 2400-2483.5MHz |
Operating mode | TDD (Time-division duplex) |
Signal standard | IEEE 802.11b/g/n |
Minimum input power | 3dBm |
Maximum output power | 36 dBm(4w) |
Uplink gain | 15±1dB |
Downlink gain | 10dB - 17dB adjustable |
(8dB attenuation range in 1dB steps) | |
Noise figure | ≤ 2.5dB |
Delay | <1uS |
Operating temperature | 25°C to + 60°C |
Weight | 0.6kg |
AP/Router Interface | SMA Female |
Antenna Interface | RP-SMA Male |
Instructions :
1: Connect Antenna to the Wi-Fi Booster.
Caution: The Booster antenna interface can only connect antenna, Don’t connect to any other wireless products in any case, otherwise it will result in equipment malfunction or damage.
2: Connect Wireless AP/Router or Wireless Network Card to the Wi-Fi Booster.
Tips: Users can also use other shielded cables to connect, but the cable length should be as short as possible, preferably not exceeding 3m.
3: Power up the Wi-Fi Booster.
At first, the Light of the LED is very dark. When the data is being transmitted, the light will become very
bright. The more dense data transmission, the more bright light.
Caution: Before Power up the Wi-Fi Booster, you must Power up the AP/Router first.
4: Adjust the Antenna position and angle, make the Wi-Fi Booster achieve the best performance.
The adjustment method of the Downlink Gain :
Attention
1: The default Downlink gain is 13dB, It is not the higher the better, You must ensure that the final
transmit power must not be larger than 36dBm (4w).
2: The Downlink gain is too high may cause the booster not work correctly, The wireless link cannot be successfully connected, or even lead to the booster damage.
3: You need to reduce the Downlink gain when it's combined with a high-power AP/Router.
4: You need to increase the Downlink gain when it's combined with a low-power AP/Router.
Signal problem & installation technique supporting
1.If still weak signal receipt after installation, please check if outdoor antenna point to signal tower correctly or elsewhere has stronger signal and confirm signal strength achieve-70DBM.
2.If still have no signal after installation, please check our device power adapter whether connected perfectly? And connectors connect well.
3. If strength is not steady, please check if outdoor and indoor antenna is too close; please ensure outdoor antenna has distance of 10 meters at least, with a barrier and not in a same horizontal line.
4. Packed the outdoor connector by waterproof glue, otherwise wet reduce the signal cover area.