Name: mobile signal booster/ repeater cell phone repeater tri band 2g/3g/4g signal booster/repeater
Brand: Lintratek
Availability: InStock

Product Details

Product Description

_{mobile signal booster/ repeater cell phone repeater tri band 2g/3g/4g signal booster/repeater}

SAMPLE ROOM

WHY CHOOSE LINTRATEK?

Cell phone becomes especially helpful when people get into critical situations. In case of emergency a timely call can save somebody’s life.

Unfortunately, there are still some places where they can find themselves “out of coverage” ,no signal at all... Usually those places are either too far from the cell phone base station or located inside underground constructions, for example:

· Parking lots, tunnels
· Big stores, office buildings
· Cars, boats etc.
· House in remote areas

Lintratek come, to save you from the bad signal!!!

· Excellent Quality

· Exquisite appearance

· High Technology

· Considerate service

FAQ and Sollution

F:After installed booster signal not be very good, indoor signal coverage very small.

1. Adjust outdoor antenna’s location and direction.

2. Check whether cable connected well.

3. Put more higher receiving antenna’s position, which can received more good signal.

4. Change another bigger power booster.

5. Change another high gain receiving antenna.

F: Cellphone signal full bar, but communication quality bad.

Too closer distance of indoor and outdoor antenna,

need more separation far distance away between antennas.

F: After installed booster not only signal be good, but also more bad.

Too closer distance of indoor and outdoor antenna,

need more separation far distance away between antennas.

F: Works good for long time, suddenly signal bad.

1. Check outdoor cable connectors whether flooding water.

2. Check power lights whether working normal.

3. If cable not flooding water and power light working normal

then the booster could be problem need send back factory repair.

Specification for Signal Repeater

Specifications
Model No		KW23F-GDW 2g/3g/4g signal booster/repeater
Parameter data		Uplink	Downlink
Frequency Range		869~915/1710~1785/1920~1980MHz	935~960/1805~1880/2110~2170MHz
Output Power		23±2dBm	23±2dBm
Gain		70±2dB	70 ±2dB
Bandwidth		Wide Band
Ripple in Band		≤5dB
Intermodulation Products	9KHz~1GHz	≤ -36 dBm
	1GHz~12.75GHz	≤ -30 dBm
Spurious Emission	9KHz~1GHz	≤ -36 dBm
	1GHz~12.75GHz	≤ -30 dBm
Noise Figure @ max. gain		≤ 6 dB
VSWR		≤3
MTBF		>50000 hours
Power Supply		AC:100~240V, 50/ 60Hz;DC:5V 2A
Power Comsumption		< 5W
Impedance		50 ohm
Mechanical Specification
RF Connector		N-Female N
Cooling		Heatsink Convection cooling
Dimensions (D x W xH )		27017060
Weight		< 3.8Kg
Installation Type		Wall Installation
Environment Conditions		IP40
Humidity		< 90%
Operating Temperature		-10°C ~ 55°C

Signal Booster Full Sets

· 1 - Outdoor antenna like YAGI antenna or panel antenna
· 2 - Indoor Omni ceiling antenna
· 3 – Power adapter
· 5 - User manual
· 6 - 2g/3g/4g signal booster/repeater
· 7 - 10 meters outdoor cable and 2 meter indoor cable

Product Show

Signal Repeater Installation (Take KW20L-GD repeater as an example)

Step 1:

Install outdoor receiving antenna on roof or other good signal places, where cell phone signal must more than 4 bars of service. The outdoor receiving antenna generally adopts the yagi or Logperiodic antenna, the antenna must be installed level, pointing in the direction the base station.

Step 2:

The outdoor receiving antenna connected to the indoor amplifier input port(BTS) through more than 10 meters jumper wire.

Step 3:

The indoor antenna connected to the amplifier output port(MS), the indoor antenna usually have ceiling mount or whip antenna, the antenna height to 2 meters more than the best.

Step 4:

After two antenna was connected, in the indoor and outdoor antenna under the premise of not look straight and separated by a wall, plugged in electricity.

Step 5:

Check your cell phone signal whether enhance , if it is not ideal, you can adjust the direction of the outdoor antenna or higher the installation position to improve. Note that goof outdoor signal is half of success.

Step 6:

The joint of outdoor antenna and feeder line should wrapped well with the waterproof tape, do the “Drop of bending” before the feeder line into the room, prevent the water through the feeder line into the indoor when rainy day.

Packaging & Shipping

Trade process: