Product Details

Product Description

For Aemrica Single band1900MHz signal repeater for PCS cell phone signal amplifier mobile signal booster

Specification

Model No		KW17A-PCS
Parameter data		Uplink	Downlink
Frequency Range	PCS	1850~1910 MHz	1930 ~ 1990MHz
Output Power		10 ±2dBm	17 ±2dBm
Gain		60 ±2 dB	65±2dB
Bandwidth		60M
Ripple in Band		PCS≤6dB
Spurious Emission	9KHz~1GHz	≤ -36 dBm
	1GHz~12.75GHz	≤ -30 dBm
Intermodulation Products	9KHz~1GHz	≤ -36 dBm
	1GHz~12.75GHz	≤ -30 dBm
VSWR		≤3
MTBF		>50000 hours
Power Supply		AC:100~240V, 50/ 60Hz;DC:5V 1A
Power Comsumption		< 3W
Impedance		50 ohm
Mechanical Specification
RF Connector		N-Female N
Dimensions (DWH )		1409530(mm)
Cooling		Heatsink Convection cooling
Net weight		< 0.45Kg
Packing size (DWH )		25024065(mm)
Gross weight		< 0.7Kg
Installation Type		Wall Installation
Environment Conditions		IP40
Humidity		< 90%
Operating Temperature		-10 °C ~ 55°C

How should you install repeater (very easy and simple):

Step 1: Use your mobile phone to test signal strength outside house or on roof, -70dbm is the basic requirement (full bar).

Step 2 Install outdoor antenna in that location and keep adjusting, point it to signal tower station, try to get best signal.

Step3: Run outdoor coaxial cable into building in a convenient location to connect with signal repeater.

step 4: Mount your indoor antenna with signal repeater

step5: Power up signal repeater device to check the signal inside, moving outdoor antenna until you get satisfied signal.

Note: Connect outdoor (BTS) port with outdoor antenna, connect indoor ANT(MS) port with indoor antenna, outdoor antenna is mounted at a higher position. Both antennas should be 10 meters far away from each other at least.

Indoor and outdoor antenna must be separated by wall.