Specifications

55/30 Internal Mixing Machine;
Easy but accurate operation;
Easy cleaning and colour changing;
Environmentally friendly;

55/30 Internal Mixing Machine

 

Character:

1.This machine posseses temperature and time control system for easy but accurate operation and best decentralization;

2.Tilt-able mixing chamber and mechanical shaft sealing design for easy cleaning and colour changing;

3.About 6-10 minutes mixing time per batch,its efficient is 2 times of wheel type mixer;

4.Pressure sealed mixing chamber to assure the quaity of mixed material and also prevent environment polltion;

5.This machine is ruggedization and easy for operation and maintance,low malfunction,save both time and power;

 

Main Parameters

Capacity	125L
Rotor speed(front/back)	30/24.5 r/min
Top peg cylinder diameter	320mm
Compressed air pressure	0.5-0.7Mpa
Cooling water pressure	0.2-0.4Mpa
Steam pressure	0.5-0.8Mpa
Main motor power	75Kw
Main motor speed	990r/min
Tilt angle	140°
Tilt motor power	2.2Kw
Outline dimension	3750x1950x3550mm
Weight	8000Kg

 

 

 

Operating procedures
1. The machine operator must go through security education and technical training, familiar with the equipment operating procedures of rear can mount guard;
2. Before the computer, the operating personnel should wear good labor protection supplies;
3. Must be checked before starting the interfere with equipment operation stuff around, clean up the machine;
4. Keep the workplace clean and tidy around the machine, the roads, open the ventilation equipment (suction fan), maintain workshop air circulation;
5. Open the water supply, gas supply, drainage valve, check the water table, water table, hydraulic table is normal;
6. Boot commissioning, found that when there is abnormal sound or other malfunction should be shut down immediately;
7. Check the door material, on the roof bolt, hopper whether can normal open it;
8. Whenever possible, anchored on the top, must be on the top switch control knob to the up position;
9. In the process of mastication and found card phenomenon, with the lifter rod or other tools, banned direct pay material on hand;
10. Roof bolt must be raised before shutdown, reset the hopper going back. Shut the door material, to stop without electricity;
11. After work, close all power, water, air, oil source.

 

 

 

Advantages:

 

1.Maximum Dispersion & High Production 
Double blades with special spiral angle, proper clearance & high cooling effect gives excellent dispersion which can not be obtained from an open mill. Its production is 4 to 5 times more than an ordinary mixing mill thus saving on labor and electricity.

 

2.Super sealing,no powder leakages.

Both sides of the rotor blades are injected welding a iron alloy ring, which assures sealing and protects the blades from abrasion.Imported bakelite sealing ring,which make super sealing.The chamber around are designed with groove,then embeded with rubber stip,this make sure the whole mixing chamber is well sealed. 

3.No Foundation Requirement 
The Kneader has a common bed plate for all parts and not require foundation. 

4.Easy Cleaning & Colour Change 
Mixing chamber can be tilted down for 140degree, which enables easy cleaning, because of this, different coloured compounds can be made without trouble. 

5.Easy Operation 
Easy operation with Push-buttons and hand lever valves from the operation board.

 

6.Short Mixing Time 
Mixing time ranges from 6 to 12 minutes depending on compound's specific gravity.