Ceramic Drying machine

 The hot winds in the lower part blow to the upper part of the internal surface evenly along the hot wind cabinet, and then blow into the bottom vent hole along the internal surface. All hot winds and wet winds are discharged from the exhaust blower. The products after mold injection directly fall onto the mold on the worktable.

The machine can achieve rapid mold injection, with advantages of even heating and non-deformation. The hot wind is obtained through electrical heating, with advantages of tidy, clean and non-pollution. The mold injection temperature can be adjusted according to size of products, and the power consumption is small.

The forming machine applies to the mold injection of the following products under 7.