kaluos design zoro atomizer mascot HC atomzier VT150 box mod with original newest dna40 chip by Evolv

VARIANT 250W box mod

Features:

l  Pulse mode

l  Lock setting and power saving feature

l  In Variable voltage mode the VARIANT can be adjusted from 2.0-8.4 volts at 2cell lithium Polymer battery( or 2.0-12.6 volts at 3cell Lithium Polymer battery)

l  In Varible wattage mode the VARIANT can be Adjusted from 5.0-250 watts in 0.1 watt increments

l  1.3” OLED display that shows all the important parameters of your unit

l  Translucent light indicator on the top of the unit that visually alerts you on the status of your VARIANT

l  15 second cut off power if the button is held down for too long

l  Battery monitoring shuts the VARIANT off once the battery has reached the end of the charging

l  30amp limiting system protects against over current situations

l  The VARIANT allows you to use an atomizer with a resistant of at least 0.2ohms

l  Designed to use a 2cell, 7.4V Lithium Polymer batteries( or 2.0-12.6 volts at 3cell Lithium Polymer battery)

 POWERING UP THE VARIANT:

l  Slide off the back cover of the VARIANT, this will give you access to the battery compartment

l  Connect your 2cell Lithium Polymer battery to the VARIANT, MAKING SURE THE POLARITY OF THE BATTERY MATCHES THAT WITH YOUR UNIT. RESERVE POLARITY MAY VOID YOUR WARRANTY. 

l  Slide back the back cover to close the unit

l  Press the POWER button, the center button( B) in front of the unit for at least 2 seconds to turn on your VARIANT

SWITCHING MODES:

l  To switch the VARIANT between variable voltage , wattage and pulse mode, press the power button(B) 5 times

VARIANT IN VOLTAGE MODE:

l  By default upon start up the VARIANT runs in variable voltage mode. This mode allows you to adjust the voltage of the VARIANT

l  To increase the voltage setting. Press the increase button(A) to raise the voltage of the unit

l  To decrease the voltage setting. Press the decrease button( C ) to lower the voltage setting of the unit

l  To minimum voltage setting is 2.0volts

VARIANT IN WATTAGE MODE:

l  In variable wattage mode. This mode allows you to adjust the wattage of the VARIANT

l  To increase the wattage setting. Press the increase button (A) to raise the wattage of the unit

l  To decrease the wattage setting. Press the decrease button ( C) to lower the wattage setting of the unit. The minimum wattage setting is 5.0watts.

VARIANT IN PULSE MODE:

l  To use the pulse mode. Press the increase button (B) to raise the voltage of the unit, simulating the quick pressing and depressing of a mechanical mod

l  The voltage will go up to 6.0V max

l  To decrease the voltage setting. Press the decrease button(C ) to lower the voltage setting of the unit

LOCKING AND POWER SAVING:

l  Press power button ( B) and firing button (D) at the same time to lock and repeat to close screen

l  SLEEP ( screen shuts off when idle for 30 seconds)

NOTES:

l  If not in use for a long time, unplug the lithium battery from the unit

l  Do not tamper the circuit board of your VARIANT, doing so will void the warranty.