Product features:

(1)    Has a slow and electronic limit, apply to preparetions, riveting hot melt a variety of ways

(2)    Hydraulic buffers and buffer circuit, the combination of running very smooth

(3)    The product is suitable for large object processing and multipoint welding at the same time

(4)    Using heat pipes and more imported temperature control system, temperature control is accurate and reliable

How to use:

1,Fixed fusion splicer installed heating end, the fusion splicer placed on shelves, according to the heating pipe specifications required to install the corresponding die head, and Allen wrench tight, generally small in the front.
2,Put through power supply, the green light is lit, the red light goes out, said fusion splicer into automatic control state, can start operation.Note in the state of automatic temperature control, alternating red light green light will be lit by oneself, this shows that fusion splicer under control, does not affect the operation.
3,In the vertical pipe cutter to cut off the pipe material, pipe and pipe fittings at the same time without rotating promote fusion splicer die head, and operate according to the requirements of the table below, reach the heating time immediately after the pipes and pipe fittings from the die head and at the same time, rapidly without rotating linear homogeneous insert to the required depth, to form a uniform flange joint.