ABS automatic urinal sanitizer dispenser
Negotiable /Piece
Min.Order:500 Pieces
Shenzhen City Itas Sanitary Wares Co., Ltd.
ABS automatic urinal sanitizer dispenser
Features:
1: Do not install the dispenser above the mirror surface or above flowing water.
2: Do not install the dispenser with less than 2 inch(50cm)height beneath the table.
3:the sensor is at the mouth of the dispenser.the effect range is from 0-10cm undernerth the sensor.
4:the product is design for indoor use only,direct sunlight or exposed locations can destroy the infrared sensor of the product.
5:low voltage indictor when you find LED light twinkle continually while dispenser on standby mode,battery replace is necessary.
If the dispenser does not dorp.
1:you must operate dispenser several times when you first use it.
2:the liquid will congealed in winter, you need fill in some warm water(about 60 degree)
3:perhaps no liquid.
If the dispenser does not work.
1:check the battery whether the power use up or not at the right polarity
2:power switch turn off.
Cleaning
1:do not use water to wash the dispenser,clean the surface use wet towel,use dry towel to clean the battery compartment.
2:if you no use,please fill in some water,then operate dispenser several times to cleaning the output pipe and take out the battery
3:if liquid was congaealed,fill in some warm water,wait few minutes,the operate dispenser and push out the water.