Product Details

Specifications

plastic table board making machine
1, servo save energy.
2, adopt Japan MOOG parison controller.
3, Robot hand

This plastic table board making machine depend on machine electrical components , open head single ring 120L drum machine , machine for plastic jerrycan, plastic barrel making machine, inject blow moulding machine

plastic table board making machine photo

plastic table board making machine features:

1. The screw adopts high potency melt to make sure the material well mixed.

2. Adopt frequency control of motor system to reduce the power consumption.

3. Adopt horizontal movement frame to improve stability and speed.

4. The oil cylinder is in the center of the moldboard, uniform stress for quality products and increase life span.

5. High stench guild rod controller the mold open and clamp, to enhance the steadily and high efficiency.

6. The extrusion head use spreader or screw type to well mixed the thickness and easy to change different color.

7.Advanced design to eliminate the melt material degrade in the runner, to avoid the perform draw-down and the welding line.

8. The precise time control system assured good quality, suitable weight and reduces production cycle.

9. Freely to move the extrusion foundation backward or forward to make the exchange of the mold easy.

10. Multi-function bottom blowing type for shaped products.

11. The mechanical arm can take out the product automatically.

plastic table board making machine parameter

extruder
Screw diameter	120mm
L/D ratio	25:1
Screw speed	10~60r.p.m.
Drive motor	75Kw SIEMENS BEIDE
DC drive motor controller	Eurotherm UK
Heating zone with cooling fan	5 zone
Output/Capacity	180Kg/hr ( HDPE particle)
Heating capacity	5X6.5 (=32) kw
Vertical adjustment of head	500mm
Forward/Backward adjustment of head	600mm
Groove feed barrel cylinder	Have IKV
Gear box	Hard gear decelerator
Ladder and safety rails	Have

Accumulator Head
Accumulator capacity	30L(23kgHDPE)
Design	First in and first out
Heating zone	5 zone
Heating capacity	40 kw
Max die&pin diameter	600mm
Die head axis with pre-blow	Ø100mm
Accumulator push-out stroke measurement	Transducer Italy Gefran
Injection pressure	12 Mpa
Extruder stop	If material up to level or full, extruder stop

CLAMPING UNIT
Tie bar	Two tie bar
Platen size (Effective measurement )	1400(W)X1600(H)
Clamping force	960KN
Close/Open stroke	600-1400mm
Mold weight	5000kg (max)
Clamping stroke measurement	Transducer Italy GEFRAN
Hydraulic valve	Taiwan YUKEN
Number of hydraulic cylinder	1
High pressure	14 Mpa
Support parts for platen movement	Liner Guide