Sand Blaster  Model Nr.:SB-990

Specification:
Natural rubber/vinyl blast gloves.
Perforated steel flooring-abrasive large particle-separating screen and clean-out door.
Powder coated inside and out.
Extra-rugged,heavy-duty production foot valve assembly.Builtto blast with heavy steel housing and high-production brass flow valve.
Air regulator/gauge panel.
12gauge steel legs(16gauge panels)
Eliminating typical suction pick-up tubes and hoses,media metering valve puts our economy
Series blast cabinets in a entirely different class from the competition.
External flourescent lighting system.Packed in wooden case.
Overall dimension: 133*124*177cm
Work pressure range:60~125PSI

Package details:
Pcs/Ctn: 1
G.W./N.W.: 198/160kgs
Dimension: 133*96*107cm
Q‘TY/20': 20pcs
Q‘TY/40' : 40pcs

WARNING: To reduce the risk of injury, always protect eyes and face with goggles and mask, and hands and arms with heavy work gloves when spraying abrasive materials.

Place the sand blaster induction probe in the sand supply container.

How To Sandblast :

1.    Connect and open the water supply line before starting the pressure washer.

2.    Trigger the gun to relieve the air in the equipment.

3.    Start the pressure washer. See its instruction manual.

4.    Trigger the gun to activate the spray.

CAUTION: Always test spray on a scrap of similar material first! The high pressure spray could damage the surface if the sandblaster is held too close. See step 5 below.

5.    To check the distance you will need to hold the spray nozzle from the surface, start to spray at the scrap of material from a distance of several feet. Gradually move closer, checking frequently to see if the high pressure spray is damaging the surface.

6.    See the application below for the type of sand recommended for your work surface.

Always point the nozzle downward when not spraying. This prevents water from entering the sand supply. If water does get into the sand supply hose, remove the probe from the sand, hold the gun trigger open, and let the hose air dry. Always be sure the sand hose is dry before using.

Keep the sand covered to prevent the overspray from wetting the sand. Do not allow small pieces of the sand bag to fall into the sand supply. A smaller piece could prevent the flow of sand.

Cnjacks' Sand Blaster Models Review

Cnjacks’ Sand Blaster Workshop View