High Quality dent lifter Unit

use steps
1. clean surface . sag
2. use of high performance glue gun , plug in after 6 waiting for ~ 8 minutes ready to use , glue gun working temperature 165 ~ about 200 degrees , use high temperature glue gun please pay special attention safety and off child .
3. based on your body for the sheet metal super size choice sag connector , and at once sure you choose the size of super connector .
4.use heated glue gun will super squeeze uniform governance in super a connector surface , fast and the slight ponits on the sag , waiting 50 seconds or 1 minutes . note : slight placed on not sag stupidity pressure , use after super connector after clearing can be used repeatedly , the abandoning plaese don't !
5.use can be adjusted elevating tripod puller , operation in based on your size adjusting sag must be slow to readjust applied force ponits sag until complete by datumized recoup .
6.debus elevating tripod puller after , super in connector with super adhesive spraying chalaza governance dispergation agent and used in addition to film light micro remove residual super glue governance .
7.use waxing polishing machine and polishing agent finishing surface , repair after almost invisible .

note : double check ponits sag repeat whether 3 - 4 - 5 steps , important is completely ponits cave complete .