PRODUCT DESCRIPTION                                                                                          

PRODUCT INFORMATION                                                                                        

 D-219P Brush Function:

 The purpose of the peeling is to slough off the dead cells and to remove any dirt and grime that clings
 to the surface of the skin. Before any peeling is done the skin should cleaned with either viscose sponges

 or cottonpads. And the face is vaporized or steamed with warm, moist towels to soften the dead surface

 cells so that they can be more easily removed. Turning brushes also serve valid massage.

OPERATING GUIDANCE
1.Select appropriate brush and insert into the brush handle. It will be locked in place as a "KA" sound is heard.
2.Turn switch "ON "then set speed according to client's skin condition and procedure . Usually slow
peeling speed is used on dry and sensitive skin and faster speed on skin that are coarse and thick. 
3.Turn CHANGE switch, the brush will be turned clockwise then counter-clockise transitionally. 
4.The peeling starts on the neck, then on the jaw ,chin, cheeks ,upper lips , nose and forehead.
5.The way to change brush: turn switch "OFF ", then use a slight force to pull off the brush and 
insert another one.
6. Viscose sponges and warm water be used to remove excess treatment product from client's skin .
7. Kinds of brushes:
A. Bigger wool brush: for cheek, chin and forehead.
B. Smaller wool brush: for eyelids, lips and nose.
C. Sponge brush: for sensitive skin.
D Plaster brush: for dead surface or coarse skin

CAUTION
1. For skins with broken capillaries, the brush may be used very lightly over this area . For severe 
broken capillaries has to be avoided.
2. The brush should be vertical with skin face .
3. Avoid setting hair into brush.
4. Following each treatment the brush should be thoroughly cleaned by washing with soap and water 
then placed it in a small bowl of alcohol for about twenty minutes to be sure it is sterilized. When not in use,
the cleaned brush should be stored in a dry sterilizing cabinet 
5. The brush should be always moistened with water to soften the bristle.
6. A tissue is held over the brush after moistening and the machine is turned on at a slow speed for a 
few seconds in order to remove excess moisture.