PRODUCT DESCRIPTION                                                                                         

   PRODUCT INFORMATION                                                                                        

 Beauty salon equipment facial steamer

   Ozone Facial Steamer (Computer Configuration),ozone facial Vaporizer

   The basic concept of this machine is that it uses electronic heat to boil water for producing steam. And then it uses the

   ultraviolet lamp to decontaminate the steam. Finally it passes the sterilized steam to skin where needs to be cared. The

   special feature of this machine is that it has an aromatic oil container for beautician to operate easily and conveniently.  

   Its smooth and beautiful shape, high-tech parts, flat tube can be turned in all degrees, arm can be turned up and down

   at 80 degrees, aromatic oil container ....etc.

Operating Methods 

  1.  Bolt the middle pillar on the four-wheeled stand first, then insert the middle pillar into   the lower pillar and fix it, finally put the

      machine on the middle pillar.

  2.  Put the silicon slice into the steam room, and then put the cup onto it, setting the cup holder in tight position. An instrument

      has been finished assembling like this. 

  3.  Add water through the pouring hole below the standard level.

  4.  Set Vapor switch to "ON" position.

  5.  Set Ozone switch to "ON" position. 

  6.  If you want to stop operation, turn off steam switch. Light off indicates off.

Cleaning  & Maintenance

  1. This facial steamer has not only a self protection function but also an alarm function.   It will cut off power  while out of water

     and will be on automatically  in 5 minutes after  water has been put into.

  2. After using a period of time, the function and effect of the heating element will reduce    because there are some calcareous

    from the water and it attach on the heating element.Therefore, please stop using and clean it when you see there’s some dirt 

    on the heating element.Clean up as follows: Take

    approximately 200 C.C. vinegar, pour it into the water glass and add some   water to dilute until fill. Soak the heating element in

    the water, wait around 20  minutes.  Remove the heating element from the vinegar water, replace pure water and soak  the

    heating element for 5 minutes.  Dry the heating element by cloth. Done.

  3. Do not come too close to the steam. Or its high temperature will harm the skin.